What is the main aim of Automatic control combustion in pulverized fuel firing?

What is the main aim of Automatic control combustion in pulverized fuel firing? Correct Answer To maintain constant steam pressure

Automatic control combustion applied to pulverized fuel fired boilers is effective in maintaining an almost constant steam pressure under wide load variations. It also gives fast response to load changes as rate of combustion can be controlled easily and immediately.
Bissoy MCQ

Related Questions

Which separator is used to separate the pulverized coal in pulverized fuel firing?
Why is combustion rate faster when the usage of pulverized coal is done in pulverized fuel handling?
Which system was used before direct firing system in pulverized fuel firing?
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:
Which air is supplied separately to ensure complete combustion in pulverized fuel firing system?
Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
What is minimum amount of air required per m3 of gaseous fuel for complete combustion? m3/m3 of fuel b) 1/100 m3/m3 of fuel c) 1/21 m3/m3 of fuel d) 1/100 m3/m3 of fuel
With reference to 'fuel cells' in which hydrogen rich fuel and oxygen are used to generate electricity. Consider the following statements.
1. If pure hydrogen is used as a fuel, the fuel cell emits heat and water as by products.
2. Fuel cells can be used for powering buildings and not for small devices like laptop, computers.
3. Fuel cells produce electricity in the form of Alternating Current (AC).
Which of the statements given above is/are correct?
Which is not correct statement about pulverized fuel firing?
Usage of highly preheated secondary air in pulverized fuel firing helps in ______