Bissoy.com
Doctors Medicines MCQs Q&A

The numerical aperture of a coaxial cable with core and cladding indices given by 2.33 and 1.4 respectively is

The numerical aperture of a coaxial cable with core and cladding indices given by 2.33 and 1.4 respectively is Correct Answer 1.86

The numerical aperture is given by NA = √(n12 – n22), where n1 and n2 are the refractive indices of core and cladding respectively. On substituting for n1 = 2.33 and n2 = 1.4, we get NA = √(2.332-1.42) = 1.86.

Related Questions

You are setting up a network in a school. You need to network 5 computers for the file and printer sharing. You want to use some donated cable and Ethernet adapters. You identify the donated adapters as ARCnet coaxial network adapters and 10Base2 Ethernet network adapters. You install an Ethernet adapter in each of the 5 computers and connect the donated cable. The computers are NOT able to maintain reliable communication. You suspect that you are NOT using the correct type of coaxial cable. Which type of coaxial cable should you be using?
S1: Instantly the full load yanked Gordy towards the side of the bridge.
P: But the pull of the cable was too much.
Q: He could hardly feel the cable, slipping through his fingers, ripping off his gloves, and streaking over the railing like an escaping snake.
R: It smashed his hands hard against the top of the railing, causing a split - second feeling of fierce pain followed by numbness.
S: He held on to the cable; it had been hard work lifting it, and he did not want to have to start over again.
S6: Feeling a sharp burning sensation where the cable was speeding between his things, Gordy rose on tiptoe and as he did, the slithering coil of cable tightened around his left foot and yanked him over the railing.

The Proper sequence should be:
The core refractive index should be lesser than the cladding refractive index for a coaxial cable. State True/False
Multimode graded index fibers with wavelength of 0.85μm have numerical aperture of 0.29 have core/cladding diameter of ___________
Losses caused by factors such as core-cladding diameter, numerical aperture, relative refractive index differences, different refractive index profiles, fiber faults are known as ____________
What is the correct order of the development of the following? 1. Numerical control 2. Computer numerical control 3. Direct numerical control 4. Distributed numerical control
You have been given the task of installing cables for an Ethernet network in your office. The building is an older one, and-you have limited work space. In addition, the network cable will have to share the existing conduit with telephone cable, and cable segments will be up to 135 meters in length. Which cable is best suited to this installation?
A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts?

Subnetting mcq question image

1. A crossover cable should be used in place of the straight-through cable.
2. A rollover cable should be used in place of the straight-through cable.
3. The subnet masks should be set to 255.255.255.192.
4. A default gateway needs to be set on each host.
5. The subnet masks should be set to 255.255.255.0.
A step-index fibre has a numerical aperture of 0.26, a core refractive index of 1.5 and a core diameter of 100micrometer. Calculate the acceptance angle.
Which of the following statements are true? a. In overhead lines, inductance is more predominant whereas capacitance is in the cable. b. In overhead lines, capacitance is more predominant whereas inductance is in the cable. c. Cost of cable is high compared to the overhead lines. d. Cost of cable is low compared to overhead lines