Bissoy.com
Doctors Medicines MCQs Q&A

At which place GSR is measured?

At which place GSR is measured? Correct Answer palms of hand

BSR gives the baseline value of the skin resistance where as GSR is due to the activity of the sweat glands. The GSR is measured most conveniently at the palms of the hand, where the body has the highest concentration of sweat glands. The measurement is made using a dc current source.

Related Questions

In a six-digit number, the digit of thousands place is 4. The digit at ten's place is double that of digit at thousand's place and digit at hundreds places is half of the digit at thousand’s place. The digit at unit's place is half of the digit at hundred's place. Digit at Ten thousand's place is sum of the digits at thousands and hundreds place and digit at lakh's place is half the digit at ten thousands place. What will be the number?
In a five digit number, the digit at ten’s place is 8, digit at units place is one-fourth of the digit at ten’s place, the digit at thousands place is 0, digit at hundreds place is twice that of units place and the digit at ten thousand place is thrice the digit at unit’s place. What is the number?
Suppose you can travel from a place A to a place B by 3 buses, from place Bto place C by 4 buses, from place C to place D by 2 buses and from place D to place E by 3buses. In how many ways can you travel ?from A to E?
In a five-digit number, the digit at the hundreds place is double of the digit at the unit place and the digit at ten thousand place is double of the digit at the hundreds place. The digit at tens place is the smallest odd prime number and the digit at thousands place is three times the unit digit. If the digit at the unit place is the even prime number, then the number is
A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
Two sides of a rectangle were measured. One of the sides (length) was measured 10% more than its actual length and the other side (width) was measured 5% less than its actual length. The percentage error in measure obtained for the area of the rectangle is :
What is the use of the GSR Sensor?
How many pins are present in the GSR Sensor?
What will happen if we supply a voltage of 25V to the Vcc of the GSR Sensor?
How many electrodes does the GSR Sensor need?