Bissoy.com
Doctors Medicines MCQs Q&A

Which winding of the transformer has less cross-sectional area?

Which winding of the transformer has less cross-sectional area? Correct Answer High voltage winding

Winding having less cross-sectional area may be primary or secondary winding. For high voltage winding cross sectional area is less while for low voltage winding cross sectional are is more, due to inverse proportionality.

Related Questions

Consider the following given statements about auto-transformers and choose the one which is/are correct. 1. Auto-transformers require less copper as compared to a conventional,2 winding transformer of the same capacity. 2. Auto-transformers provide isolation between the primary and secondary windings. 3. Auto- transformer has less leakage reactance as compared to the conventional, 2 winding transformer of the same capacity.
Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
From the given table, what is the percentage of students scoring 40 or more, but less than 70. Scores Less than 20 Less than 30 Less than 40 Less than 50 Less than 60 Less than 70 Less than 80 No. of Students 12 19 22 31 38 46 50
A 25 KVA transformer is constructed to a turns ratio of N1/N2 = 10. The impedance of primary winding is 3+j5 ohms and of secondary winding is 0.5+j0.8 ohms. What will be the impedance of transformer when referred to primary?
From the following table, how many patients were in the age group 40 – 60? Age (years) Less than 10 Less than 20 Less than 30 Less than 40 Less than 50 Less than 60 Less than 70 No. of patients 11 15 22 29 35 45 50
The areas of 8 cylinders C1, C2, C3, C4, C5, C6, C7 and C8 are compared. No two cylinders have the same area. Either C1 or C7 is the minimum area. The area of C4 is greater than that of C1 but less than that of C5. The area of C6 is less than only C3 and C2. The area of C5 is less than that of C7 and C8. Which of the following sequence is not possible?
A 100/10, 50 VA double winding transformer is converted to 100/110 V auto transformer. tWhat will be the rating of auto transformer?
The process of voluntary winding up of solvent company is now shifted from the Companies Act, 2013 to Insolvency and Bankruptcy Code, 2016 with effect from 1st April, 2017. Which of the following differences apply?
1. Shifting of Powers from Official Liquidator to Insolvency Professional.
2. Jurisdictional Authority has been shifted from High Court to National Company Law Tribunal.
3. Governing sections, rules and regulations for Voluntary Winding has now shifted to Section 59 of the Insolvency and Bankruptcy Code, 2016.
4. Timeline for carrying out the Voluntary Winding up process under the IBC is normally of 12 months.
A 100 VA, 120/12 V transformer is to be connected so as to form a step-up transformer. A Primary voltage of 120 V is applied to the transformer. What is the secondary voltage of the transformer?
A 3-phase, 4-pole alternator has 48 stator slots carrying a 3-phase distributed winding. Each coil of the winding is short chorded by one slot pitch. The winding factor is given by ______________