Three phase converters are employed for _______________

Three phase converters are employed for _______________ Correct Answer Large kW motors

Three phase converters are employed when DC motor of very high ratings is used. In three phase converters, the advantage is the ripple frequency of the motor terminal voltage is generally higher than that in single-phase converters.
Bissoy MCQ

Related Questions

Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
Which of the following statements are correct for the A/D converters: a) The advantage of using a dual-slope A/D converter in a digital voltmeter is that its accuracy is high. b) The number of comparators in a 4-bit flash A/D converters is 15. c) The minimum number of comparators required to build an 8-bit flash A/D converter is 256. d) The number of comparators required in a 3-bit comparator type A/D converters is 8.
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
Three statements are followed by three conclusions numbered I, II and III. Assuming the statements to be true even if they do not conform to real-world knowledge, decide which of the conclusions logically follows/follow from the statements. Statements: 1. All uncles are relatives. 2. Some relatives are neighbours. 3. All neighbours are employed. Conclusions: I. Some neighbours are uncles. II. Some uncles are employed. III. Some relatives are employed.
Catalytic converters are called three-way converters because they are used to reduce the concentration of CO. HC, and NOx in the exhaust.
Election for a constituency was conducted in two phases where three contestants A, B and C contested. In first phase 48% of the total voters voted out which A and B got 32% and 46% of the votes (remaining to C). In the next phase where 75% of the remaining people voted A and B got 43% and 33% of the votes casted (Remaining to C). If the amount of votes obtained by A in phase 1 is less than the total votes obtained by B in phase 1 and C in phase 2 by 16080, then what is the total number of voters in the constituency?
A 3-phase bridge converter is given a three-phase supply in the phase sequence R-Y-B. Let the neutral to R phase voltage be Vm sinωt. The first SCR (connected to R phase) is fired at an angle of 15°. What is the maximum value at the output terminals at this instant?
Input to the diode rectifiers is always single phase while the input to the ac-dc converters is always three phase.
In FACTS line commutated converters are generally preferred than self-commutated converters.