Bissoy.com
Doctors Medicines MCQs Q&A

A duplex lap wound armature is used in six pole dc machine with six brush set. The number of current paths in this machine is?

A duplex lap wound armature is used in six pole dc machine with six brush set. The number of current paths in this machine is? Correct Answer 12

The number of parallel paths for a lap wound machine is number of parallel paths. As it is a duplex winding, it will have 6*2 = 12 parallel paths.

Related Questions

Which three statements are true about the operation of a full-duplex Ethernet network?
1. There are no collisions in full-duplex mode.
2. A dedicated switch port is required for each full-duplex node.
3. Ethernet hub ports are preconfigured for full-duplex mode.
4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
5. The host network card and the switch port must be capable of operating in full-duplex mode.
For a four pole, 16 slot armature with two coil-side/slot having lap connected progressive winding has single turn coils. The same machine is then wave wound, the emf induced in the lap wound dc machine to that of wave wound will be ________
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of flux/pole?
Calculate the number of conductors on each pole piece required in a compensating winding for a 6-pole lap-wound dc armature containing 286 conductors. The compensating winding carries full armature current. Assume ratio of pole arc/ pole pitch = 0.7.
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. Here, motor is drawing 25 A current at 1500 rpm. What is the available torque (N-m) at shaft?
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of induced emf?
The armature resistance of a 6-pole lap wound d.c. machine is 0.05 Ω. If the armature is rewound as a wave-winding, what is the armature resistance?
A 400-V, 1000-A, lap wound dc machine has 10 poles, 860 armature conductors. The number of conductors in the pole face to give full compensation if pole face covers 70% of pole span is?
A 4-pole lap wound generator with 720 armature conductors and a flux per pole of .003 Wb has an armature current of 50 A. The developed torque is _________
A 2-pole lap wound generator with 44 armature conductors and a flux per pole of .07 Wb has an armature current of 80 A. The developed torque is _________