Bissoy.com
Doctors Medicines MCQs Q&A

Calculate the value of the conduction angle for diode for R-L load with a freewheeling diode if the value of β is 226°. (Discontinuous conduction mode)

Calculate the value of the conduction angle for diode for R-L load with a freewheeling diode if the value of β is 226°. (Discontinuous conduction mode) Correct Answer 45°

The conduction angle for diode for R-L load with a freewheeling diode is β-π=226°-180°=45°. R-L load is a current stiff type of load.

Related Questions

A semi-converter with RLE load and a freewheeling diode has discontinuous load current with firing angle α and extinction angle β. The freewheeling period is
Calculate the value of the conduction angle for diode for R-L load with a freewheeling diode if the value of α is 45°. (Continous conduction mode)
A semi-converter with RLE load and a freewheeling diode has discontinuous load current with firing angle α and extinction angle β. If β < π and Vm sinβ < E then
In a single-phase half-wave circuit with RL load and a freewheeling diode, the load voltage during the freewheeling period will be
Calculate the value of the conduction angle for SCR for R-L load with a freewheeling diode if the value of β and α are 65° and 12°.
In a single-phase half-wave circuit with RL load and a freewheeling diode, the freewheeling period is
A half controlled single-phase bridge converter is supplying an R-L load. The triggering angle is α. If the load current is continuous, the duration for which the freewheeling of the load takes place in a half cycle of the input voltage is
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
By using a freewheeling diode (FD) in a rectifier with RL load, the power consumed by the load
For a Zener diode shunt regulator, the source current is IS, the Zener diode current is IZ and the load current is IL. The source voltage is VS, Zener voltage is VZ and load voltage is VL. The load resistance is RL. What is the correct option for the safe operation of the diode?