Bissoy.com
Doctors Medicines MCQs Q&A

The direct axis is taken along ________

The direct axis is taken along ________ Correct Answer Rotor pole axis

The direct axis is oriented along the rotor pole axis and the quadrature axis is 90° electrical to rotor pole axis. The direct axis is not oriented along the inter-polar axis.

Related Questions

In a survey of 25 students, it was found that 15 had taken Mathematics, 12 had taken Physics and 11 had taken Chemistry, 5 had taken Mathematics and Chemistry, 9 had taken Mathematics and Physics, 4 had taken Physics and Chemistry and 3 had taken all the three subjects. Find the number of students who had taken both Physics and Chemistry but not Mathematics.
In a survey of university students, 64 had taken Drama course, 94 had taken Dance course, 58 had taken a Singing course, 28 had taken Drama and singing course, 26 had taken Drama and dance course, 22 had taken Dance and singing course, and 14 had taken all the three courses. Find how many have taken only one course?
Steady state direct axis reactance is greater than subtransient direct axis reactance and transient direct axis reactance.
A rider is riding his bike along the sides of a square ground. He drives the bike with the speed of 10 km/h along one side, 15 km/h along another side, 18 km/h along the third side, and 20 km/h along the last side and reaches the starting point. What is the average speed of the bike along the sides of the ground?
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $$I$$P) is given by (where, A = Area of the section, $$I$$G = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $${I_{\text{P}}}$$) is given by (where, A = Area of the section, $${I_{\text{G}}}$$ = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)
Steps are given to draw an ellipse by trammel method. Arrange the steps. i. Place the trammel so that R is on the minor axis CD and Q on the major axis AB. Then P will be on the ellipse. ii. Draw two axes AB and CD intersecting each other at O. iii. By moving the trammel to new positions, always keeping R on CD and Q on AB, obtain other points and join those to get an ellipse. iv. Along the edge of a strip of paper which may be used as a trammel, mark PQ equal to half the minor axis and PR equal to half of major axis.
For an Oldham coupling used between two shafts, which among the following statements are correct? I. Torsional load is transferred along shaft axis. II. A velocity ratio of 1:2 between shafts is obtained without using gears. III. Bending load is transferred transverse to shaft axis. IV. Rotation is transferred along shaft axis.
A sample of an ideal gas is taken through the cyclic process abca as shown in the figure. The change in the internal energy of the gas along the path ca is -180 J. The gas absorbs 250 J of heat along the path ab and 60 J along the path bc. The work done by the gas along the path abc is:
In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.