Bissoy.com
Doctors Medicines MCQs Q&A

An SCR rectifier circuit is designed such that the average output voltage is 77.64 V & RMS value of output voltage is 145.873 V. Find the voltage ripple factor.

An SCR rectifier circuit is designed such that the average output voltage is 77.64 V & RMS value of output voltage is 145.873 V. Find the voltage ripple factor. Correct Answer 1.590

FF = 145.873/77.64 = 1.879 VRF = √(FF2-1) = 1.5908.

Related Questions

Consider the following statements: 1. In a silicon controlled rectifier (SCR), if the cathode gate is reverse-biased, then the SCR cannot fire at all. 2. The turn-on time of an SCR increases with temperature. 3. After an SCR is turned on, it can be made to turn off again by reverse biasing the gate. 4. Gate recovery time is the minimum time that the anode voltage must be maintained below holding voltage VH to turn off the SCR. Which of these statements are correct?
For a SCR the maximum rms on-state current is 35 A. If the SCR is used in a resistive circuit for a rectangular wave with conduction angle of 90°. Calculate the average & rms currents respectively.
A three-winding transformer is connected to an AC source with 50 V rms as shown in the following figure. Voltages induced in the secondary windings are 2 V rms and 8 V rms. The output rms voltage V0 is,
A single-phase semi-converter circuit is supplying power to a motor load. The average value of load voltage is 176.72 V and the rms value is 219.3 V. Find the VRF (voltage ripple factor).
For the rectifier circuit shown in the figure, the sinusoidal voltage (V1 or V2) at the output of the transformer has a maximum value of 10 V. The loadresistance RL, is 1 k$$\Omega $$. If lav is the average current through the resistor RL, the circuit corresponds to a
Electronics mcq question image
A ripple counter designed with J-K flip-flops provided with CLEAR (Cl.) input is shown in the figure. In order that this circuit functions as a MOD-12 counter, the NAND gate inputs (X1 and X2) should be
Electronics mcq question image
A step-down delta-star transformer, with per-phase turns ratio of 5 is fed from a 3-phase 1100 V source. The secondary of this transformer is connected through a 3-pulse type rectifier, which is feeding an R load. The power delivered to the load is 6839.3 Watts. The maximum value of the load current is √2 x 22 A. Fin, the rms value of output voltage Vo (rms)
A single-phase diode B-2 rectifier is fed from a 250 V, 50 Hz source & connected to a load of R = 400 Ω. Design a capacitor filter such that the ripple factor of the output voltage is less than 5 %. Find the value of the capacitance of the C filter.
For an SCR the average & rms values of current are I/4 & I/2 respectively. Calculate the average on-state current rating (ITAV). Take maximum RMS on-state current = 35 A.
In a series RC circuit, 12 V(rms) is measured across the resistor and 15 V(rms) is measured across the capacitor. The rms source voltage is