Bissoy.com
Doctors Medicines MCQs Q&A

In case of a C filter, the AC is not allowed to pass to the load by

In case of a C filter, the AC is not allowed to pass to the load by Correct Answer short circuiting the AC component

AC ripples are not allowed to pass, by S.C the AC ripples as the C is always connected in parallel with the load.

Related Questions

Consider a circuit as shown in figure The circuit is (1) Constant K low-pass filter (2) Constant K high-pass filter (3) The m-derived low-pass filter (4) The m-derived high-pass filter
A rotary drum filter with 30% submergence is used to filter concentrated aqueous slurry of calcium carbonate containing 15lb of solids per cubic foot of water. The pressure–drop is 2011Hg. If the filter cake contains 50% mixture (wet basis), calculate the filter area required to filter 10 gal/min of slurry. The filter cycle time is 5 min. The specific cake resistance depends on the pressure–drop as: α (ft/lb) = α (Δp)0.26, where α = 2.90×1010 Viscosity of the filtrate = 6.72×10-4 lb/ft-s. Density of calcium carbonate = 168.8 lb/ft3. Neglect filter medium resistance.
Butterworth lowpass filter has a parameter, filter order, determining its functionality as very sharp or very smooth filter function or an intermediate filter function. If the parameter value is very high, the filter approaches to which of the following filter(s)?
Butterworth lowpass filter has a parameter, filter order, determining its functionality as very sharp or very smooth filter function or an intermediate filter function. If the parameter value is of lower order, the filter approaches to which of the following filter(s)?
If the low pass filter described by the difference equation y(n)=0.9y(n-1)+0.1x(n) is converted into a high pass filter, then what is the frequency response of the high pass filter?
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
The filter order of a Butterworth lowpass filter determines whether it is a very sharp or extremely smooth filter function, or an intermediate filter function. Which of the following filters does the filter approach if the parameter value is very high?
For a Band Pass Filter, the slope of the filter is given as 80dB/decade. The order of the Band Pass Filter is __________
For a Band Pass Filter, the slope of the filter is given as 40dB/decade. The order of the Band Pass Filter is __________
Find the gain and phase angle of the second order low pass filter? Where pass band gain of the filter is 5, frequency and the high cut-off frequency of the filter are 3000Hz and 1kHz.