Bissoy.com
Doctors Medicines MCQs Q&A

In case of an L filter connected with a rectifier in series with the load, it offers ________ impedance to ac whereas _______ resistance to dc respectively.

In case of an L filter connected with a rectifier in series with the load, it offers ________ impedance to ac whereas _______ resistance to dc respectively. Correct Answer high, low

It offers high impedance to AC such as the AC ripples do not pass through the load.

Related Questions

A rotary drum filter with 30% submergence is used to filter concentrated aqueous slurry of calcium carbonate containing 15lb of solids per cubic foot of water. The pressure–drop is 2011Hg. If the filter cake contains 50% mixture (wet basis), calculate the filter area required to filter 10 gal/min of slurry. The filter cycle time is 5 min. The specific cake resistance depends on the pressure–drop as: α (ft/lb) = α (Δp)0.26, where α = 2.90×1010 Viscosity of the filtrate = 6.72×10-4 lb/ft-s. Density of calcium carbonate = 168.8 lb/ft3. Neglect filter medium resistance.
A half wave rectifier, operated from a 50Hz supply uses a 1000µF capacitance connected in parallel to the load of rectifier. What will be the minimum value of load resistance that can be connected across the capacitor if the ripple% not exceeds 5?
At a 33kV 50 Hz to a bus a load of 35 MW is connected. To improve the power factor to unity a synchronous phase modifier is connected taking 5 MW. If the SPM is represented as delta connected impedance, where in each phase we have capacitor connected parallel to resistance forming RC parallel network, then the value of this resistance is ___________
Z1 and Z2 are connected in series to form a load. A wattmeter’s current coil is connected in series with the load, whereas its pressure coil is connected across Z2. The wattmeter reads:
At a 33kV 50 Hz to a bus a load of 35 MW is connected. To improve the power factor to unity a synchronous phase modifier is connected taking 5 MW. If the SPM is represented as delta connected impedance, where in each phase we have capacitor connected parallel to resistance forming RC parallel network, then the value of this capacitance is __________
Butterworth lowpass filter has a parameter, filter order, determining its functionality as very sharp or very smooth filter function or an intermediate filter function. If the parameter value is very high, the filter approaches to which of the following filter(s)?
Butterworth lowpass filter has a parameter, filter order, determining its functionality as very sharp or very smooth filter function or an intermediate filter function. If the parameter value is of lower order, the filter approaches to which of the following filter(s)?
When a certain type of filter is connected across the R load of a full wave bridge type diode biased rectifier, the following output voltage waveform is obtained The filter connected is most likely to be a/an
When a certain type of filter is connected across the R load, of a full wave bridge diode biased rectifier the following output current waveform is obtained. The filter connected is most likely a
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?