The flow of a fluid in pipe does not depend upon which of the following factors?

The flow of a fluid in pipe does not depend upon which of the following factors? Correct Answer Gaussian equation

The fluid flow in a pipe depends on a number of factors. Reynolds’s number is one such factor. It is in turn dependent on the density, viscosity and velocity of the fluid. Also the number and types of bends in pipe, valves and other kinds of fittings affect the flow of fluid.
Bissoy MCQ

Related Questions

Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
Two pipes A and B can fill an empty cistern in 18 and 27 hours, respectively. Pipe C can drain the entire cistern in 45 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few Pipe A was turned off and Pipe B was turned on instantly. In all, it took 55 hours to fill the cistern. For how many hours was Pipe B turned on?
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by (where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3.μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
The pressure drop per unit length of pipe incurred by a fluid 'X' flowing through pipe is $$\Delta {\text{p}}.$$  If another fluid 'Y' having both the specific gravity & density just double of that of fluid 'X', flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be
Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the
The flow through a circular pipe is laminar. Now, the fluid through the pipe is replaced with a more viscous fluid and passed through the pipe again with the same velocity. What can we say about the nature of this flow?
A tank has an inlet and outlet pipe. The inlet pipe fills the tank completely in 2 hours when the outlet pipe is plugged. The outlet pipe empties the tank completely in 6 hours when the inlet pipe is pluggeed. If there is a lekage also which is capable of draining out the liquid from the tank at half of the rate of outet pipe,them what is the time taken to fill the emty tank when both the pipes are opened?
A water line is buried underground in dry soil that has an assumed initial temperature of 4.5 degree Celsius. The pipe may have no flow through it for long period of time, yet it will not be drained in order that no freezing occurs, the pipe must be kept at a temperature not lower than 0 degree Celsius. The pipe is to be designed for a 30 hour period at the beginning of which the soil surface temperature suddenly drops to – 17 degree Celsius. Workout the minimum earth covering needed above the water pipe so as to prevent the possibility of freezing during 36 hour cold spell. The soil in which the pipe is buried has the following properties Density = 640 kg/m3 Specific heat = 1843J/kg degree Thermal conductivity = 0.345 W/m degree
The velocity of a fluid in a pipe of diameter D is V. The pipe is connected to another pipe of diameter 2D. Reynolds number in the pipe of diameter D in relation to the pipe of diameter 2D is
Find the appropriate relation for quantity 1 and quantity 2 in the following question: An artificial kund is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the kund at the same time during which the kund is filled by the third pipe alone. The second pipe fills the kund 5 hours faster than the first pipe and 4 hours slower than the third pipe. Quantity 1: The time required by the first pipe? Quantity 2: Time taken by all three pipes to fill the Kund simultaneously