Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not possible when the signal is analog?

Which of the following is not possible when the signal is analog? Correct Answer Data compression

Data compression is done by checking redundancy in data. Data redundancy checking is only possible when the data is in digital form and hence data compression cannot be done in analog signals.

Related Questions

Which one of the following is true with regard to a CPU having a single interrupt request line and single interrupt grant line? i) Neither vectored nor multiple interrupting devices is possible. ii) Vectored interrupts is not possible but multiple interrupting devices is possible. iii) Vectored interrupts is possible and multiple interrupting devices is not possible. iv) Both vectored and multiple interrupting devices are possible.
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
If the signal to be analyzed is an analog signal, we would pass it through an anti-aliasing filter with B as the bandwidth of the filtered signal and then the signal is sampled at a rate __________
What are the important block(s) required to process an input analog signal to get an output analog signal?
The S/H is a digitally controlled analog circuit that tracks the analog input signal during the sample mode and then holds it fixed during the hold mode to the instantaneous value of the signal at the time the system is switched from the sample to the hold mode.
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?
A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
In general, a digital system designer has better control of tolerances in a digital signal processing system than an analog system designer who is designing an equivalent analog system.
A signal contains components at 400 Hz and 2400 Hz This signal modulates a carrier of frequency 100 MHz. However, after demodulation, it is found that the 400 Hz signal component is present. The channel bandwidth is 15 kHz. What is the reason for the higher frequency signal not to be detected properly?
Consider the following threads, T1, T2, and T3 executing on a single processor, synchronized using three binary semaphore variables, S1, S2, and S3, operated upon using standard wait() and signal(). The threads can be context switched in any order and at any time. T1 T2 T3 While(true) { Wait(S3); Print(“C”); Signal (S2); } While(true) { Wait(S1); Print(“B”); Signal (S3); } While(true) { Wait(S2); Print(“A”); Signal (S1); }   Which initialization of the semaphores would print the sequence BCABCABCA….?