Bissoy.com
Doctors Medicines MCQs Q&A

What is the bandwidth of the signal if the upper sideband frequency and the lower sideband frequency are 7350 KHz and 7210 KHz respectively?

What is the bandwidth of the signal if the upper sideband frequency and the lower sideband frequency are 7350 KHz and 7210 KHz respectively? Correct Answer 140KHz

Bandwidth = upper sideband frequency – lower sideband frequency = 7350 – 7210 = 140KHz.

Related Questions

Which of the following statements are correct w.r.t. the vestigial sideband modulation? (i) As compared to SSB-SC, the bandwidth of the vestigial sideband becomes larger. (ii) The filter required needs to have a sharp cut-off. (iii) The transmitted vestige of the undesired sideband compensates for the loss of the wanted sideband.  (iv) Vestigial sideband is used in TV for transmission of the picture and sound signals.   Choose the correct answer from the code given below:
What will be the upper sideband and lower sideband frequencies for amplitude modulation of a 5-kHz signal with 40-kHz carrier frequency?
What is the upper sideband frequency if the carrier frequency and the modulating signal frequency is 30 KHz and 80 Hz respectively?
In an AM system receiver. the mixer translates the carrier frequency fc to a fixed intermediate frequency of 450 kHz. Given a broadcast signal of frequency 900 kHz. What is the corresponding image frequency when a superhetrodyne receiver is employed with local oscillator frequency greater than the broadcast signal frequency?
A frequency division multiplexing system is used to multiplex 24 independent voice signals. Single sideband modulation is used for the transmission. Each voice signal is allotted a bandwidth of 4 kHz. What is the overall transmission bandwidth of the channel ?
A signal containing only two frequency components (3 kHz and 6 kHz) is sampled at the rate of 8 kHz, and then passed through a low pass filter with a cut-off frequency of 8 kHz. The filter output
A resonant circuit has a lower critical frequency of 7 kHz and an upper critical frequency of 13 kHz. The bandwidth of the circuit is
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
A signal contains components at 400 Hz and 2400 Hz This signal modulates a carrier of frequency 100 MHz. However, after demodulation, it is found that the 400 Hz signal component is present. The channel bandwidth is 15 kHz. What is the reason for the higher frequency signal not to be detected properly?
A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t). The resulting signal is passed through an ideal low pass filter with bandwidth 1 kHz. The output of the low pass filter would be :