Bissoy.com
Doctors Medicines MCQs Q&A

A good electrical relay contact tip should have higher arc resistance.

A good electrical relay contact tip should have higher arc resistance. Correct Answer True

A good electrical relay contact tip should have higher arc resistance. Too much arching or sparking can damage the contact tip. If the arching become severe, it can even weld the contact point which can led excess of current flow and can damage other components.

Related Questions

Consider the following statements with respect to a relay: 1. A relay is energized if NC contacts are opened. 2. The pickup current is the minimum relay coil current required to keep a relay energized. Which of the above statements is/are correct?
If a transformer is provided with differentially connected relay. To prevent the mal operation of the relay, the relay relay operating coil is biased with ______
Which electrical relay contact tip material has the highest electrical conductivity?
Total resistance in welding is composed of: (i) Resistance of electrode (ii) Contact resistance between electrode and work piece (iii) Contact resistance between two work piece plates (iv) Resistance of work piece Which of the following is correct?
Which electrical relay contact tip material has the highest thermal conductivity?
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Match the following Device Conversion of Energy (a) Windmill (i) Chemical Energy to electrical energy (b) Bulb (ii) Kinetic Energy to Electrical Energy (c) Electrical Cell (iii) Sound Energy to Electrical energy (d) Microphone (iv) Electrical Energy to Light Energy
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
Given are the steps to draw a tangent to given arc even if center is unknown and the point P lies on it. Arrange the steps. Let AB be the arc. i. Draw EF, the bisector of the arc CD. It will pass through P. ii. RS is the required tangent. iii. With P as center and any radius draw arcs cutting arc AB at C and D. iv. Draw a perpendicular RS to EF through P.
Arrange the following stages in a sequence, such that they result in an ogee curve between two parallel lines AB and CD, such that they are the tangents to the arc. m) Join the adjacent ends B and C with a straight line. n) Divide the line BC into four parts using the points P1, P2, P3. o) Draw lines such that they pass through the points P1, P2, P3, and are perpendicular to the line BC. p) Draw the perpendicular lines through the points B and C such that they cut the lines passing through P1, P3 respectively at E and F. q) With the center E draw an arc BP2 and with center F draw an arc P2C, thus arc BP2C is required ogee curve.