Bissoy.com
Doctors Medicines MCQs Q&A

Using the frequency scaling technique, convert 10kHz cut-off frequency of the low pass filter to a cutoff frequency of 16kHz.(Take C=0.01µF and R=15.9kΩ)

Using the frequency scaling technique, convert 10kHz cut-off frequency of the low pass filter to a cutoff frequency of 16kHz.(Take C=0.01µF and R=15.9kΩ) Correct Answer 9.94kΩ

To change a cut-off frequency from 10kHz to 16kHz,multiply 15.9kΩ resistor. =10kHz/16kHz =0.625. ∴ R =0.625×15.9kΩ =9.94kΩ. However 9.94kΩ is not a standard value. So, a potentiometer of 10kΩ is taken and adjusted to 9.94kΩ.

Related Questions

Consider a circuit as shown in figure The circuit is (1) Constant K low-pass filter (2) Constant K high-pass filter (3) The m-derived low-pass filter (4) The m-derived high-pass filter
If the low pass filter described by the difference equation y(n)=0.9y(n-1)+0.1x(n) is converted into a high pass filter, then what is the frequency response of the high pass filter?
If H(s) is the transfer function of a analog low pass normalized filter and Ωu is the desired pass band edge frequency of new low pass filter, then which of the following transformation has to be performed?
The low-pass active filter shown in the figure has a cut-off frequency of 2 kHz and a pass band gain of 1.5. The values of the resistors are
Electronics mcq question image
A rotary drum filter with 30% submergence is used to filter concentrated aqueous slurry of calcium carbonate containing 15lb of solids per cubic foot of water. The pressure–drop is 2011Hg. If the filter cake contains 50% mixture (wet basis), calculate the filter area required to filter 10 gal/min of slurry. The filter cycle time is 5 min. The specific cake resistance depends on the pressure–drop as: α (ft/lb) = α (Δp)0.26, where α = 2.90×1010 Viscosity of the filtrate = 6.72×10-4 lb/ft-s. Density of calcium carbonate = 168.8 lb/ft3. Neglect filter medium resistance.
Find the gain and phase angle of the second order low pass filter? Where pass band gain of the filter is 5, frequency and the high cut-off frequency of the filter are 3000Hz and 1kHz.
Which of the following statements are correct? 1. A lowpass filter passes low frequencies and stops high frequencies. 2. A highpass filter passes high frequencies and rejects low frequencies 3. A bandpass filter passes frequencies within a frequency band and attenuates frequencies outside the band. 4. A bandstop filter passes frequencies within the band and blocks/attenuates frequencies outside a frequency band.
The cutoff frequency of the low pass Butterworth filter is the arithmetic mean of the two cutoff frequencies as found above.
The low pass, high pass, band pass and band stop filters can be designed by applying a specific transformation to a normalized low pass filter.
The resonant frequency of m-derived low pass filter in terms of the cut-off frequency of low pass filter is?