Bissoy.com
Doctors Medicines MCQs Q&A

Find the output voltage for differential amplifier, Where Vin->Induced input noise. +Vno b) VO= -(RF/R1)×(Vd/Vno) c) VO= --Vno d) VO= -×Vno

Find the output voltage for differential amplifier, Where Vin->Induced input noise. +Vno b) VO= -(RF/R1)×(Vd/Vno) c) VO= --Vno d) VO= -×Vno Correct Answer VO= -+Vno

As the input of the differential amplifier is provided with induced noise voltage, the output voltage will be equal to Vo=-+Vno Where Vno–> Output noise.

Related Questions

An amplifier has a noise equivalent temperature of 170 K. If the amplifier is used with a source having an equivalent noise temperature of TS=450 K, the output noise power of the amplifier is:
The Common Mode Rejection Ratio (CMRR) of a differential amplifier using an operational amplifier is 100 dB. The output voltage for a differential input of 200 μV is 2 V. The common mode gain is
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
In a receiver the input signal is 100 V, while the internal noise at the input is 10 V. With amplification the output signal is 2 V, while the output noise is 0.4 V. The noise figure of receiver is
Consider a voltage series feedback network, where amplifier gain = 100, feedback factor = 5. For the basic amplifier, input voltage = 4V, input current=2mA. Find the input resistance of the network.
An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ & Output resistance of 2.5 kΩ.The input resistance of the current shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is
If source resistance in an amplifier circuit is zero, then voltage gain (output to input voltage ratio) and source voltage gain (output to source voltage ratio) are the same.
In the question one statement is given, followed by two conclusions, I and II. You have to consider the statement to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statement. Statement: A function is a relation between a set of input elements and a set of possible output elements where each input is related to exactly one output. Conclusion I: Every input element is related to every output element. Conclusion II: Every input element is related to one element of the output.
A sinusoidal input voltage Vin of frequency ω is fed to the circuit shown in the figure, where C1 ≫ C2. If Vm is the peak value of the input voltage, then output voltage (Vout) is
Electronics mcq question image
If for an amplifier the common mode input signal is vc, the differential signal id vd and Ac and Ad represent common mode gain and differential gain respectively, then the output voltage v0 is given by