Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the circuit shown below which reduces the impact of the input bias current. If IB1 = IB2 = Input bias current, then determine the value of R3 so that the output voltage (v0) is not impacted by the input bias current.
Consider an inverting amplifier circuit designed using an op amp and two resistors, R1 = 10 kΩ and R2 = 1 MΩ. If the op amp is specified to have an input bias current of 100 nA and an input offset current of 10 nA, find the output dc offset voltage resulting.
Which factor affect the input offset voltage, bias current and input offset current in an op-amp
Consider an inverting amplifier with a nominal gain of 1000 constructed from an op amp with an input offset voltage of 3 mV and with output saturation levels of ±10 V. If the effect of VOs(input offset voltage) is nulled at room temperature (250C), how large an input can one now apply if the circuit is to operate at a constant temperature?
Which of the following statements are correct for an ideal constant voltage source? 1. Its output voltage remains absolutely constant whatever the change in load current. 2. It possesses zero internal resistance so that internal voltage drop in the source is zero. 3. Output voltage is provided by the source would remain constant irrespective of the amount of current drawn from it. 4. Output voltage provided by the source varies with the amount of current drawn from it.
Consider an inverting amplifier with a nominal gain of 1000 constructed from an op amp with an input offset voltage of 3 mV and with output saturation levels of ±10 V. If the effect of VOs(input offset voltage) is nulled at room temperature (250C). The circuit is to operate at a temperature in the range 0°C to 75°C and the temperature coefficient of VOS is 10 μV/°C?
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
Mention a step to reduce the output offset voltage caused due to input bias current?
Find the maximum possible output offset voltage, which is caused by the input offset voltage Vio=15mv?
Determine the maximum output offset voltage caused by input offset current