Bissoy.com
Doctors Medicines MCQs Q&A

Schwinger reversed phase coupler is a waveguide coupler designed so that the path lengths for the two coupling apertures are the same for_________

Schwinger reversed phase coupler is a waveguide coupler designed so that the path lengths for the two coupling apertures are the same for_________ Correct Answer Uncoupled port

Schwinger reversed phase coupler is a waveguide coupler designed so that the path lengths for the two coupling apertures are the same for uncoupled port so that the directivity is essentially independent of frequency.

Related Questions

A machine started malfunctioning due to some issues with the coupling. The coupling emplaced in the machine was Oldham. The only coupling available in the workshop is Hooke’s coupling. So Oldham coupling can be replaced by Hooke’s coupling.
Which of the following statements are comes for Network Critical Path? 1. The path of critical activities, which links the start and end events is critical path 2. It is the path of activities having zero float 3. It is the path of events having zero slack 4. The sum of the duration of the critical activities along a critical path gives the duration of the Project
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
Moreno crossed-guide coupler is a waveguide directional coupler consists of four waveguides at right angle.
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
When a 1-phase transformer is connected in parallel, there are four conditions for proper parallel operation, but when two or 3-phase transformer paralleling is done, there are two additional points along with those four conditions applied for 1-phase. Statement 1 - The phase sequence must be the same. Statement 2 - The phase shift between primary and secondary voltages must be the same for all transformers connected in parallel. From the above two Statements (s), which is/are the correct conditions in this regard?
Coupling factor of a directional coupler must be maximum and is a key factor that determines the performance of the coupler.
In a four-bar chain it is required to give an oscillatory motion to the follower for a continuous rotation of the crank. For the lengths of 50 mm of crank and 70 mm of the follower, determine theoretical maximum length of coupler. The minimum length of the coupler will be
The coupling and directivity of couplers with apertures in planar lines can be adjusted as per the requirement of the application.
In a two-electron atomic system having orbital and spin angular momenta $${l_1}{l_2}$$  and $${s_1}{s_2}$$  respectively, the coupling strengths are defined as $${\Gamma _{{l_1}{l_2}}},\,{\Gamma _{{s_1}{s_2}}},\,{\Gamma _{{l_1}{s_1}}},\,{\Gamma _{{l_2}{s_2}}},\,{\Gamma _{{l_1}{l_2}}}$$      and $${\Gamma _{{l_2}{s_1}}}.$$  For the jj coupling. scheme to be applicable, the coupling strengths must satisfy the condition