Quality factor of a coaxial cable transmission line is independent of the medium between the wires of the transmission line.

Quality factor of a coaxial cable transmission line is independent of the medium between the wires of the transmission line. Correct Answer False

Quality factor is dependent on the permeability of the medium between the inner and outer conductor of the co-axial cable. For example, air has twice the quality factor as that of Teflon filled co-axial fiber.
Bissoy MCQ

Related Questions

You are setting up a network in a school. You need to network 5 computers for the file and printer sharing. You want to use some donated cable and Ethernet adapters. You identify the donated adapters as ARCnet coaxial network adapters and 10Base2 Ethernet network adapters. You install an Ethernet adapter in each of the 5 computers and connect the donated cable. The computers are NOT able to maintain reliable communication. You suspect that you are NOT using the correct type of coaxial cable. Which type of coaxial cable should you be using?
S1: Instantly the full load yanked Gordy towards the side of the bridge.
P: But the pull of the cable was too much.
Q: He could hardly feel the cable, slipping through his fingers, ripping off his gloves, and streaking over the railing like an escaping snake.
R: It smashed his hands hard against the top of the railing, causing a split - second feeling of fierce pain followed by numbness.
S: He held on to the cable; it had been hard work lifting it, and he did not want to have to start over again.
S6: Feeling a sharp burning sensation where the cable was speeding between his things, Gordy rose on tiptoe and as he did, the slithering coil of cable tightened around his left foot and yanked him over the railing.

The Proper sequence should be:
A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts?

Subnetting mcq question image

1. A crossover cable should be used in place of the straight-through cable.
2. A rollover cable should be used in place of the straight-through cable.
3. The subnet masks should be set to 255.255.255.192.
4. A default gateway needs to be set on each host.
5. The subnet masks should be set to 255.255.255.0.
You have been given the task of installing cables for an Ethernet network in your office. The building is an older one, and-you have limited work space. In addition, the network cable will have to share the existing conduit with telephone cable, and cable segments will be up to 135 meters in length. Which cable is best suited to this installation?
Twisted pair wires, coaxial cable, optical fiber cables are the examples of:
An air coaxial cable has attenuation of 0.022 and phase constant of 104.7, then the quality factor of a λ/2 short circuited resonator made out of this material is:
A cable TV service uses a single coaxial cable with a bandwidth of 860 MHz to transmit multiple TV signals to subscribers. Each TV signal is 6 MHz wide. How many channels can be carried?
A coaxial cable of uniform cross-section contains an insulating material of dielectric constant. The radius of the central wire is 0.01 m and that of the sheath is 0.02 m. The capacitance per kilometre of a cable is
The velocity factor of a coaxial cable is typically 0.8. What is the speed of transmission?
Statement 1: Brookfield viscometer is an example of Coaxial Cylinder Viscometer. Statement 2: Working principle of a Brookfield viscometer: Two coaxial cylinders. Liquid is filled in between them. The viscosity produces torque which is directly proportional to the shear stress.