In finite time regulator:

In finite time regulator: Correct Answer There is no restriction on the controllability of the plant

In finite time regulator there is no restriction on the controllability of the plant. This is because is always finite and instability does not impose any problems in finite-time control.
Bissoy MCQ

Related Questions

What are the conditions to be satisfied by a voltage source for using it in switching regulator. i. It must supply the required output power and the losses associated with the switching regulator ii. It must be large enough to supply sufficient dynamic range line and load variations iii. It must be sufficient high to meet the minimum requirement of the regulator system to be designed iv. It may be required to store energy for a specified amount of time during power failure especially if the system is designed for a computer power supply.
A Zener voltage regulator will cease to act as a voltage regulator if Zener current becomes ___________
A designer requires a shunt regulator of approximately 20 V. Two kinds of Zener diodes are available: 6.8-V devices with rz of 10 Ω and 5.1-V devices with rz of 30 Ω. For the two major choices possible, find the load regulation. In this calculation neglect the effect of the regulator resistance R.
A transistor series regulator has the following specifications: VIN=15V, VZ=8.3V, β=100, R=1.8KΩ, RL=2KΩ. What will be the Zener current in the regulator circuit?
How many numbers of conditions of flow are to be followed while designing the cross regulator and head regulator?
In a coal mine district, air flows at a rate of 30 m3/s at a pressure of 1200 Pa. The density of air is 1.2 kg/m3. The mine management decided to reduce the flow rate of air to 20 m3/s using a regulator without changing the ventilation pressure. The area of regulator expressed in m2 will be
A fan circulates 24 m3/s of air at a pressure of 1200 Pa in a ventilation district. It is intended to reduce the air quantity to 16 m3/s by placing a regulator. Assuming the pressure remains unchanged, the size of the regulator in m2 is
Two splits A and B are ventilated from an intake airway. Resistances of the splits are 0.5 Ns2m-8 and 0.8 Ns2m-8 respectively. A regulator is placed in split B to maintain a flow of 15 m3/s and 10 m3/s in splits A and B respectively as shown in the figure. The size of the regulator in m2 is
Mine Ventilation mcq question image
While performing an experiment to determine the gain for an ideal operational amplifier having finite gain, a student mistakenly used the equation 1 + R2/R1 where R2 is the feedback resistance. What is the percentage error in his result? Given A is the finite voltage gain of the ideal amplifier used.
A nondeterministic finite automation with ε-moves is an extension of nondeterministic finite automation.