Bissoy.com
Doctors Medicines MCQs Q&A

Normalized response of a dynamic system refers to:

Normalized response of a dynamic system refers to: Correct Answer Characteristic feature of a response due to specific excitation irrespective of its amplitude

Normalization refers to the desired to the reference value and normalized response of the dynamic system refers to the characteristic feature of a response due to specific excitation irrespective of its amplitude.

Related Questions

Consider the following statements for dynamic characteristics of a measurement system: 1. Fidelity is defined as the degree to which a measurement system indicates changes in the measured quantity without any dynamic error. 2. Dynamic error is the difference between the true value of the quantity changing with time and the value indicated by the measurement system if no static error is assumed. 3. Measuring lag is the retardation in the response of a measurement system to changes in the measured quantity. Which of the above statements are correct?
Below are given two sets, Set - I which gives modalities of operant conditioning and Set - II which provides the types of reinforcement, the types of responses (responses made or withheld) and the presence or absence of cue. Match the two sets and indicate your answer by choosing from the code : Set - I (Modalities of operant conditioning procedures) Set – II           (Conditions and contexts) (a) Reward training (i) Positive reinforcement, response made, with cue present (b) Escape training (ii) Positive reinforcement, response withheld with cue absent (c) Discriminated omission training   (iii) Positive reinforcement, response made with cue absent (d) Active avoidance   (iv) Negative reinforcement, response made with training (e) Punishment training (v) Positive reinforcement, response withheld with cue present   (vi) Negative reinforcement, response withheld with cue absent  
Consider the following statements comparing static RAM with dynamic RAM: In static RAM typical cell requires more number of transistors than the dynamic RAM. Power consumption per bit of static RAM is less than that of dynamic RAM. Dynamic RAM is less expensive than the static RAM. Which of the above statements are correct?
Consider the following statements with reference to the response of a control system: 1. A large resonant peak corresponds to a small overshoot in transient response. 2. A large bandwidth corresponds to slow response. 3. The cut-off rate indicates the ability of the system to distinguish the signal from noise 4. Resonant frequency is indicative of the speed of transient response. Which of the above statements are correct?
In MATLAB, the impulse response of the step response of a system is ___ to the step response of the impulse response of the system.
If the normalized admittance at a point on a transmission line to be matched is 1+j1.47. Then the normalized susceptance of the stub used for shunt stub matching is:
Multiplying the normalized field with the normalized array factor gives ___________
Corrected and normalized conditions of temperature, pressure and volume, normalized by their respective critical conditions is called
The below curve represents the relation between the normalized creep rate with normalized stress. In which of the following region the power law is valid?
The following curve represents the relation between the normalized creep rate with normalized stress. In which of the the region, the Harper-Dorn Creep law is valid?