Bissoy.com
Doctors Medicines MCQs Q&A

Transfer function of a system is used to calculate which of the following?

Transfer function of a system is used to calculate which of the following? Correct Answer The output for any given input

Transfer function of a system is that ratio of Laplace output to the Laplace input at zero initial conditions and which is used to calculate the output for any given input.

Related Questions

Let h(t) denote the impulse response of a causal system with transfer function $${1 \over {s + 1}}.$$  Consider the following three statements:
S1 : The system is stable.
S2 : $${{h\left( {t + 1} \right)} \over {h\left( t \right)}}$$  independent of t for t > 0.
S3 : A non-causal system with the same transfer function is stable.
For the above system,
Consider the following properties attributed to state model of a system: 1. State model is unique. 2. Transfer function for the system is unique. 3. State model can be derived from transfer function of the system. Which of the above statements are correct?
A stable linear time invariant (LTI) system has a transfer function $$H\left( s \right) = {1 \over {{s^2} + s - 6}}.$$    To make this system causal it needs to be cascaded with another LTI system having a transfer function H1(s). A correct choice for H1(s) among the following options is
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
In a closed loop system, the process to be controlled is an integrating process with transfer function $$\frac{1}{{2{\text{s}}}}.$$ The controller proposed to be used in an integral controller with transfer function $$\frac{1}{{{{\text{T}}_1}{\text{s}}}}.$$  When a step change in set point is applied to such a closed loop system, the controlled variable will exhibit
A single-input single-output feedback system has forward transfer function G(s) and feedback transfer function H(s). It is given that |G(s)H(s)| < 1. Which of the following is true about the stability of the system?
In MS Excel, what is function inside another function called? A. Round Function B. Sandwich function C. Switch function D. Nested function 
The transfer function of a discrete time LTI system is given by
$$H\left( z \right) = {{2 - {3 \over 4}{z^{ - 1}}} \over {1 - {3 \over 4}{z^{ - 1}} + {1 \over 8}{z^{ - 2}}}}$$
Consider the following statements:
S1 : The system is stable and causal for
$$ROC:\left| z \right| > {1 \over 2}$$
S2 : The system is stable but not causal for
$$ROC:\left| z \right| S3 : The system is neither stable nor causal for
$$ROC:{1 \over 4} Which one of the following statements is valid?
Under section 42 of the Transfer of Property Act, 1882 if a person has a right to transfer property, after exercising a right to revoke a previous transfer, a transfer of such property by him will imply an exercise of: