Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements with respect to the feedback from the control systems: 1. The feedback can improve stability or be harmful to stability if it is not properly applied. 2. The feedback can always improve stability. 3. In many situations, the feedback can reduce the effect of noise and disturbance on system performance. 4. In general, the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located. Select the correct statements.
Consider the following statements with respect to the feedback of the control systems. i. Feedback can improve stability or be harmful to stability if it is not properly applied. ii. Feedback can always improve stability iii. In many situations the feedback can reduce the effect of noise and disturbance on system performance. iv. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.
Consider the following statements with respect to the feedback of the control systems: 1. Feedback can improve stability or be harmful to stability if it is not properly applied. 2. Feedback can always improve stability 3. In many situations the feedback can reduce the effect of noise and disturbance on system performance. 4. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.
Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
The block diagram of a feedback compensated system is given below: Which of the following statements are correct? a) When Kt = 0, the feedback compensation is in-effective and the system is uncompensated b) When Kt = 0, the feedback compensation is most effective and system is compensated c) The performance of the compensated system depends on Kt and T d) The performance of the compensated system does not depend on T
Two refrigerators M and N operate in series. The refrigerator M absorbs energy at the rate of 1 kW from a body at temperature 400 K and rejects energy as heat to a body at a temperature T. The refrigerator N absorbs the same quantity of energy which is rejected by the refrigerator N from the body at temperature T, and rejects energy as heat to a body at temperature 800 K. If both the refrigerators have the same C.O.P., what is the value temperature T?
Match the following Types of mechanism Motion achieved P. Scott Russel mechanism 1. Intermittent motion Q. Geneva mechanism 2. Quick return motion R. Off set slider crank mechanism 3. Simple harmonic motion S. scotch Yoke mechanism 4. Straight line motion
Which of the below are inversions of slider crank mechanism?
1. Oscillating cylinder engine mechanism
2. Toggle mechanism
3. Radial cylinder engine mechanism
4. Quick return mechanism
Based on the given para, answer the following question. Sensitivity considerations often are important in the design of Control Systems. Because all physical elements have properties that change with environment and age, we cannot always consider the parameters of the Control System to be completely stationary over the entire operating life of the system. For instance, the winding resistance of an electric motor changes as the temperature of the motor rises during operation. Control systems with electric components may not operate normally when first turned on because of the still-changing system parameters during warmup. This phenomenon is sometimes called “morning sickness”. Most duplicating machines have a warmup period during which time operation is blocked out when first turn on. A good Control System should be: (a) Very sensitive to parameter variations (b) Insensitive to parameter variations (c) Insensitive to input commands (d) Sensitive to input commands Which of the above are correct?
Consider the circuit shown below. Consider A: Current-shunt feedback B: Current-series feedback C: Voltage-shunt feedback D: Voltage-series feedback Which of the above are present?