Consider a simple mass spring friction system as given in the figure K1, K2 are spring constants f-friction, M-Mass, F-Force, x-Displacement. The transfer function X(s)/F(s) of the given system will be :

What is the monoisotopic and average mass of valine? Given data: Mass of the most abundant isotope of Carbon (C°)=12.0000, Mass of most abundant isotope of Hydrogen (H°)=1.0078, Mass of most abundant isotope of Oxygen (O°)=15.9949, Mass of most abundant isotope of Nitrogen (N°)=14.0031, The average mass of Carbon (C)=12.011, The average mass of Hydrogen (H)=1.008, The average mass of Oxygen (O)=15.999, The average mass of Nitrogen (N)=14.007.

A

99.068 and 99.2361

B

99.216 and 99.326

C

99.111 and 99.321

D

99.068 and 99.132

A helical spring, of negligible mass, and which is found to extend 0.25 mm under a mass of 1.5 kg, is made to support a mass of 60 kg. The spring and the mass system is displaced vertically through 12.5 mm and released. Find the velocity of the mass, when it is 5 mm below its rest position.

A

0.36 m/s

B

0.46 m/s

C

0.56 m/s

D

none of the mentioned

A mass m is connected on either side with a spring each of spring constants k₁ and k₂. The free ends of springs are tied to rigid supports. The displacement of the mass is x from equilibrium position.
Classical Mechanics mcq question image

Which one of the following is true?

A

The force acting on the mass is $${\left( {{k_1}{k_2}} \right)^{\frac{1}{2}}}x$$

B

The angular momentum of the mass is zero about the equilibrium point and its Lagrangian $$\frac{1}{2}m{{\dot x}^2} - \frac{1}{2}\left( {{k_1} + {k_2}} \right){x^2}$$

C

The total energy of the system is $$\frac{1}{2}m{{\dot x}^2}$$

D

The angular momentum of the mass is $$mx\dot x$$ and Lagrangian of system is $$\frac{m}{2}\dot x + \frac{1}{2}\left( {{k_1} + {k_2}} \right){x^2}$$

A centrifugal clutch has four shoes. When the clutch is at rest, each shoe is pulled against a stop by a spring so that it leaves a radial clearance of 10 mm between the shoe and the rim. The pull exerted by the spring is then 700 N. The mass centre of the shoe is 150 mm from the axis of the clutch. If the internal diameter of the rim is 500 mm, the mass of each shoe is 6 kg, the stiffness of each spring is 75 N/mm and the coefficient of friction between the shoe and the rim is 0.35; find the power transmitted by the clutch at 400 r.p.m.

A

3.439 kW

B

34.39 kW

C

3439 kW

D

3.439 W

A centrifugal clutch has four shoes. When the clutch is at rest, each shoe is pulled against a stop by a spring so that it leaves a radial clearance of 7.5 mm between the shoe and the rim. The pull exerted by the spring is then 600 N. The mass centre of the shoe is 120 mm from the axis of the clutch. If the internal diameter of the rim is 350 mm, the mass of each shoe is 5 kg, the stiffness of each spring is 60 N/mm and the coefficient of friction between the shoe and the rim is 0.2; find the speed of the centrifugal clutch, if the power transmitted is 40.168 kW.

A

83.779 r.p.m.

B

800 r.p.m.

C

104.66 r.p.m.

D

1000 r.p.m.

A helical spring, of negligible mass, and which is found to extend 0.25 mm under a mass of 1.5 kg, is made to support a mass of 60 kg. The spring and the mass system is displaced vertically through 12.5 mm and released. Determine the frequency of natural vibration of the system.

A

6 Hz

B

4.98 Hz

C

5.98 Hz

D

none of the mentioned

A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.

A

0.014 m/sec

B

0.015 m/sec

C

0.016 m/sec

D

0.013 m/sec

A mass m is suspended from a spring. Its frequency of oscillation is f. The spring is cut into two halves and the same mass is suspended from one of the two pieces of the spring. The frequency of oscillation of mass will be ___________

A

√2 f

B

f/2

C

f

D

2f

When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the deflection of the spring ($$\delta $$) is given by (where d = Diameter of spring wire, n = No. of turns of the spring and C = Modulus of rigidity for the spring material)

A

$$\frac{{{\text{W}}{{\text{D}}^3}{\text{n}}}}{{{\text{C}}{{\text{d}}^4}}}$$

B

$$\frac{{2{\text{W}}{{\text{D}}^3}{\text{n}}}}{{{\text{C}}{{\text{d}}^4}}}$$

C

$$\frac{{4{\text{W}}{{\text{D}}^3}{\text{n}}}}{{{\text{C}}{{\text{d}}^4}}}$$

D

$$\frac{{8{\text{W}}{{\text{D}}^3}{\text{n}}}}{{{\text{C}}{{\text{d}}^4}}}$$

A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be

A

$$\frac{\tau }{2}$$

B

$$\tau $$

C

$$2\tau $$

D

$$4\tau $$

Consider a simple mass spring friction system as given in the figure K1, K2 are spring constants f-friction, M-Mass, F-Force, x-Displacement. The transfer function X(s)/F(s) of the given system will be :

Related Questions