Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the circuit shown below. Find the voltage across 2Ω resistor due to the 10V voltage source using Superposition theorem.
What are the steps required in sequence to solve a circuit using superposition theorem? (a) Select any one source and short circuit all other voltage sources. (b) Find out the current or voltage across the required element, due to the source under consideration. (c) Open all current sources, if the internal impedance is not known. If known replace them by their impedances. (d) Add all the individual effects produced by individual sources to obtain the total current in or across the voltage element. Code :
The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
Match List I with List-II and select the correct answer using the code given below the lists:   List I   List II A.  Superposition   theorem 1.  Impedance matching in audio   circuits B.  Thevenin's   theorem 2.  Linear bilateral networks C.  Kirchhoff's   voltage and  current laws 3.  Large network in which   currents in few elements to be   determined D.  Maximum power   transfer theorem 4.  Currents and voltage in all   branches of a network
In the figure shown below. Find the voltage across 2Ω resistor due to all source using Superposition theorem.
Two resistors are in series: a 5.6 kΩ resistor and a 4.7 kΩ resistor. The voltage drop across the 5.6 kΩ resistor is 10 V. The voltage across the 4.7 kΩ resistor is
Find the current in R2 of the given circuit, using the superposition theorem.
Circuit Theorems and Conversions mcq question image
In the circuit shown, find the current through 4Ω resistor using Superposition theorem.
Which of the following statements is/are correct? 1. A continuous-time system is a system in which, continuous-time input signals are applied, resulting in continuous-time output signals. 2. A system is said to be linear if it follows the superposition theorem. 3. A system is said to be non-linear if it follows the superposition theorem.
The input voltage V1 of the circuit the circuit is 2V and resistor has a resistance of 1KΩ. The cut-in voltage of the silicon diode is 0.7V and the reverse saturation current is 10-8A. The temperature at which diode operates is 30°C. The voltage across resistor when diode starts conducting is _________________