Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements regarding electronic voltmeter. 1) The detection of low-level signals is not possible using the electronic voltmeter 2) MOSFET is used at the input of the electronic voltmeter 3) Vacuum tube voltmeters (VTVM) consumes more power as compared to any non-electronic voltmeter. Which of the following is / are incorrect?
A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
The input impedance of the permanent magnet moving coil (PMMC) voltmeter is infinite. Assuming that the diode shown in the figure below is ideal, the reading of the voltmeter in Volts is
In the following figure, the transmitter Tx sends a wideband modulated RF signal via a coaxial cable to the receiver Rx. The output impedance ZT of Tx, the characteristic impedance Z0 of the cable, and the input impedance ZR of Rx are all real. Which one of the following statements is TRUE about the distortion of the received signal due to impedance mismatch?
After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
An average responding rectifier type electronic ac voltmeter has its scale calibrated in terms of the rms value of a sine wave. If a square wave voltage of peak amplitude of 100 V is measured using this voltmeter, what will be the reading indicated by the meter?
An electronic device when fed with the numbers, rearranges them in a particular order following certain rules. The following is a step-by-step process of rearrangement for the given input of numbers. Input :- 85 16 36 04 19 97 63 09 Step I :- 97 85 16 36 04 19 63 09 Step II :- 97 85 63 16 36 04 19 09 Step III :- 97 85 63 36 16 04 19 09 Step IV :- 97 85 63 36 19 16 04 09 Step V :- 97 85 63 36 19 16 09 04 (for the given input step V is the last step). Which of the following will be the last step for the given input ? Input :- 03 31 43 22 11 09
A word arrangement machine, When given an input line of words, rearranges it in every step following a certain rule. Following is an illustration of an input line of words and various steps of rearrangement.
Input: gone are take enough brought station
Step 1: take gone are enough brought station
Step 2: take are gone enough brought station
Step 3: take are station gone enough brought
Step 4: take are station brought gone enough
And Step 4 is the last step for this input. Now, find out an appropriate step in the following question following the above rule. Question:
Input: car on star quick demand fat
What will be the third step for this input ?
An electronic device rearranges numbers step-by-step in a particular order according to set of rules. The device stops when the final result is obtained.
Input: 84 15 35 04 18 96 62 08
Step 1: 96 84 15 35 04 18 62 08
Step 2: 96 84 62 15 35 04 18 08
Step 3: 96 84 62 35 15 04 18 08
Step 4: 96 84 62 35 18 15 04 08
Step 5: 96 84 62 35 18 15 08 04
And Step 5 is the last step for this input. Now, find out an appropriate step in the following question following the above rule. Question:
Input: 16 09 24 28 15 04
What will be the third step for this input ?
Expression for input impedance of a transmission line in terms of load impedance and characteristic impedance is: