Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In DM, the quantizer is a simple ________ bit and ______ level quantizer.
A signal is sampled at 8 kHz and is quantized using 8-bit uniform quantizer. Assuming SNRq for a sinusoidal signal, the correct statement for PCM signal with a bit rate of R is
Consider a system whose input r and output y are related by the equation $$y\left( t \right) = \int\limits_{ - \infty }^\infty {x\left( {t - \tau } \right)} h\left( {2\tau } \right)d\tau $$
Signal Processing mcq question image
Where h(t) is shown in the graph
Which of the following four properties are possessed by the system? BIBO: Bounded input gives a bounded output
Causal: The system is causal.
LP : The system is low pass.
LTI: The system is linear and time-invariant.
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
The figure shows the plot of y as a function of x
Differential Equations mcq question image
The function shown is the solution of the differential equation (assuming all initial conditions to be zero) is
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?
A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
If for an amplifier the common mode input signal is vc, the differential signal id vd and Ac and Ad represent common mode gain and differential gain respectively, then the output voltage v0 is given by
Consider the system shown in the figure below. The transfer function $$\frac{{Y\left( z \right)}}{{X\left( z \right)}}$$  of the system is
Signal Processing mcq question image
For the discrete-time system shown in the figure, the poles of the system transfer function are located at
Signal Processing mcq question image