Bissoy.com
Doctors Medicines MCQs Q&A

What is the region after the stop band frequency in the magnitude frequency response of a low pass filter?

What is the region after the stop band frequency in the magnitude frequency response of a low pass filter? Correct Answer Stop band

From the magnitude frequency response of a low pass filter, we can state that the region after stop band frequency is known as ‘stop band’ where the signal is stopped or restricted.

Related Questions

Which of the following statements are correct? 1. A lowpass filter passes low frequencies and stops high frequencies. 2. A highpass filter passes high frequencies and rejects low frequencies 3. A bandpass filter passes frequencies within a frequency band and attenuates frequencies outside the band. 4. A bandstop filter passes frequencies within the band and blocks/attenuates frequencies outside a frequency band.
What is the region between stop band and the pass band frequencies in the magnitude frequency response of a low pass filter?
If δP is the forbidden magnitude value in the pass band and δS is the forbidden magnitude value in th stop band, then which of the following is true in the stop band region?
The low pass, high pass, band pass and band stop filters can be designed by applying a specific transformation to a normalized low pass filter.
If δP is the forbidden magnitude value in the pass band and δS is the forbidden magnitude value in the stop band, then which of the following is true in the pass band region?
Consider a circuit as shown in figure The circuit is (1) Constant K low-pass filter (2) Constant K high-pass filter (3) The m-derived low-pass filter (4) The m-derived high-pass filter
What is the region between origin and the pass band frequency in the magnitude frequency response of a low pass filter?
If hlp(n) denotes the impulse response of a low pass filter with frequency response Hlp(ω), then what is the frequency response of the high pass filter in terms of Hlp(ω)?
If H(s) is the transfer function of a analog low pass normalized filter and Ωu is the desired pass band edge frequency of new low pass filter, then which of the following transformation has to be performed?
The low-pass active filter shown in the figure has a cut-off frequency of 2 kHz and a pass band gain of 1.5. The values of the resistors are
Electronics mcq question image