Bissoy.com
Doctors Medicines MCQs Q&A

If the value of a resistor creating thermal noise is doubled. The noise power generator is therefore ________

If the value of a resistor creating thermal noise is doubled. The noise power generator is therefore ________ Correct Answer unchanged

If the value of resistor creating thermal noise is doubled then also the noise power generator remains unaffected, since the two are independent of each other.

Related Questions

Transient stability of the generator is dependent on (a) generator reactance; lower reactance decreases peak power and increases initial rotor angle. (b) how heavily the generator is loaded. (c) generator inertia; higher the inertia, slower the rate of the change of angle. (d) generator output during fault Which of the above is incorrect?
Which of the following power station is situated in Madhya Pradesh state? Satpura Thermal Power Station Shree Singaji Thermal Power Station Sanjay Gandhi Thermal Power Station Amarkantak Thermal Power Station
The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
A series is given with one term missing. Select the correct alternative from the given ones that will complete the series. Bakrehswar Thermal Power Station, Bandel Thermal Power Station, Santaldih Thermal Power Station, Kolaghat Thermal Power Station, ?
A certain series circuit consists of a $$\frac{1}{8}$$ W resistor, a $$\frac{1}{4}$$ W resistor and a $$\frac{1}{2}$$ W resistor. The total resistance is 1200 Ω. If each resistor is operating in the circuit at its maximum power dissipation, total current flow is
A 40 Ω resistor is in parallel with an 80 Ω resistor. Current in the 40 Ω resistor is 6 A. How will you add a third resistor and what will be its value if the line-current is to be 10 A?
It is found that 10A current passes through a resistor of 10°hms. The resistor has 5% tolerance . The error in measurement of current can be as high as 5%. What is max error in measurement of power, calculated from measured value of I and the nominal value of resistor?
In a turbopump system using a gas generator cycle, the flame temperature in the separate gas generator where a small portion of overall propellant is burned is _________ compared to the main gas generator and its mixture ratio is _________ compared to that of the main gas generator.
A source maintains a current I in a resistor of resistor of resistance R. If V is the potential difference across the resistor. The electrical energy dissipated in the resistor in time is given _____
Two resistors are in series: a 5.6 kΩ resistor and a 4.7 kΩ resistor. The voltage drop across the 5.6 kΩ resistor is 10 V. The voltage across the 4.7 kΩ resistor is