Bissoy.com
Doctors Medicines MCQs Q&A

The transmitter and receiver are not synchronized at all, in asynchronous transmission.

The transmitter and receiver are not synchronized at all, in asynchronous transmission. Correct Answer False

In Asynchronous transmission, each character is signified by start and stop bits. Thus, the transmitter and receiver are synchronized frame-by-frame using the start and stop bits, not by data bits.

Related Questions

The transmitter and receiver are frame-by-frame synchronized using the data bits in asynchronous transmission.
Which of the following statements regarding binary counters are correct? (a) Clock inputs of all the flip - flops of a synchronous counter are applied from the same source whereas those in an asynchronous counter are from different sources. (b) The asynchronous counter has ripple effects whereas the synchronous counter does not. (c) Only J-K flip-flops can be used in synchronous counters whereas asynchronous counters can be designed with any kind of flip flops. (d) Latches can be used for designing asynchronous counters. Code :
The ratio between transmitter chip clock rate and the difference between the transmitter chip clock and difference between transmitter and receiver chip clock rates is called ___________
Which type of ARQ system introduces the transmission delay between the transmitter and receiver before the reception of frame at receiver for the purpose of error detection?
Which of the following statements are correct with reference to superheterodyne receivers? (i) The main advantage of the superheterodyne receiver is its better tracking (ii) The main advantage of the superheterodyne receiver is an improvement in sensitivity (iii) The image channel rejection in superheterodyne receiver comes from IF stages only (iv) The image channel rejection in the superheterodyne receiver comes from the RF stage only Choose the correct answer from the code given below:
Antenna noise temperature of a system is 210 K, noise temperature of transmission line is 123 K, loss of a transmission line connecting the antenna to receiver is 1.41 and noise temperature of the receiver cascade is 304 K. then the total system noise temperature is:
The ______ of out-of-band signal with bandpass characteristic of the receiver gives the interference in the receiver owing to out-of-band energy at the transmitter.
Which digital signal processing technique takes preventive measures to protect the transport streams from errors caused by noise and interference in the transmission channel in DTV transmitter and receiver?
The method in which the user’s receiver and the reference station are assumed not to be synchronized in time is called as _______
Which of the following parameters should the transmitter and the receiver agree upon before starting a serial transmission?