To demodulate a USB SSB signal, the receiver must ________

To demodulate a USB SSB signal, the receiver must ________ Correct Answer be set to USB mode and reinsert the carrier

Single side band suppresses the carrier and uses only one of the two sidebands. The two sidebands carry exactly the same information and thus removing a sideband does not have any effect on the signal. To demodulate upper sideband of signal it is necessary that the receiver must be set to USB mode and have the ability to reinsert the carrier.
Bissoy MCQ

Related Questions

Indicate which of the following circuits could not demodulate SSB:
One of the following cannot be used to demodulate SSB:
Which one of the following circuits could not demodulate SSB?
h,J,K,L,M,N and O are the only legislators eligible to vote on Bills 1,2 and 3, each of which will be passed if at least four legislators eligible vote in favor of it. each legislator must vote on all three bills; on abstentions are possible. The following is known : *H must vote against all three bills; each of the other legislators must vote in favor of at least one bill and against at lest one bill. *j must vote against Bills 1. *O Must vote against Bills 2 and 3. * L must the same way that K dose on all three bills.*N must vote the same way that O dose on all three bills. which of the following must vote in favor of Bill 1 ?
h,J,K,L,M,N and O are the only legislators eligible to vote on Bills 1,2 and 3, each of which will be passed if at least four legislators eligible vote in favor of it. each legislator must vote on all three bills; on abstentions are possible. The following is known : *H must vote against all three bills; each of the other legislators must vote in favor of at least one bill and against at lest one bill. *j must vote against Bills 1. *O Must vote against Bills 2 and 3. * L must the same way that K dose on all three bills.*N must vote the same way that O dose on all three bills. If any bill is to be passed,which of the following must be among the legislators who vote in favor of it?
In a receiver the input signal is 100 V, while the internal noise at the input is 10 V. With amplification the output signal is 2 V, while the output noise is 0.4 V. The noise figure of receiver is
A receiver is operated at a temperature of 300 K. The transistor used in the receiver have an average output resistance of 1 k. The Johnson noise voltage for a receiver with a bandwidth of 200 kHz is
In a receiver, if the noise figure of the mixer stage in the receiver is 7 dB, then the equivalent noise temperature is given that the receiver is operating at 290 K:
The sender asks the receiver what is to be sent to him (the receiver). He also takes care of the aspirations of the receiver while he designs and transmits the message. This is the chief guiding tenet of the
Why is no carrier signal transmitted when the amplitude of the modulating signal is 0 in an SSB transmission?