In the making of the shear force diagram or the bending moment diagrams, one method is used, distributed load. In this the distributed load will be considered positive if ____________

In the making of the shear force diagram or the bending moment diagrams, one method is used, distributed load. In this the distributed load will be considered positive if ____________ Correct Answer Loading acts upward

The loading acting upward is considered to be positive. This is done as to decrease the time used for the calculations. If the method of sections is being applied at the complex sections for the determination of the unknown forces, much time is required for it. Thus the main motto is to make the calculations easy and make the less use of time.
Bissoy MCQ

Related Questions

In the making of the shear force diagram or the bending moment diagrams, one method is used, distributed load. In this the distributed load will be considered positive if?
If any force is applied in the direction of the positive x-axis, and there are three different points in bending moment diagram on which the moment of this force is to be calculated. Then if these three points are on the positive side of the y-axis with varying distance, then what will be the direction of the moment caused by the force to the individual point?
The effect of twisting moment and shear force on the bolt group cause ____ whereas bending moment and shear force cause ________
Calculate bending moment of dead load given total load = 14n/mm2, Dead load bending moment dead weight of slab = 12kn/m2, dead weight of w.c = 1.76kn/m2, span length is 10.4m?
If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
The moment of the force in bending moment diagram is the product of the force and the perpendicular distance of the axis and the point of action of the force.
A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
Sinking of an intermediate support of a continuous beam
i) reduces the negative moment at support
ii) increases the negative moment at support
iii) reduces the positive moment at center of span
iv) increases the positive moment at center of span
The correct answer is
In bolted moment end plate connection, bending moment , axial force and shear force are transferred by
If any force is applied in the direction of the positive x-axis, and there are three different point on which the moment of this force is to be calculated. Then if these three points are on the positive side of the y-axis with varying distance, then what will be the direction of the moment caused by the force to the individual point?