Bissoy.com
Doctors Medicines MCQs Q&A

The coal sample contains=80%; H=4%; O=2%; N=12%; S=2%, the remainder is ash and then calculate the volume of air required for perfect combustion of 1kg of fuel assuming STP conditions.

The coal sample contains=80%; H=4%; O=2%; N=12%; S=2%, the remainder is ash and then calculate the volume of air required for perfect combustion of 1kg of fuel assuming STP conditions. Correct Answer weight of oxygen required=10.65kg; volume of the oxygen=8166.6l

The total weight of oxygen required for combustion is calculated by taking every component equation. It will be 2.45kg and then calculate the volume of oxygen. At STP conditions 32g of oxygen occupies 22.4l volume. Calculate for 2450g and then find weight of oxygen required as we know 100kg of gas requires 23kg of oxygen.

Related Questions

In order to burn a fuel completely, which of the following basic conditions must be fulfilled? 1. Supply enough air for complete combustion of fuel. 2. Secure low turbulence for thorough mixing of fuel and air. 3. Maintain a furnace temperature high enough to ignite the incoming fuel air mixture. 4. Provide a furnace volume large enough to allow time for combustion to be completed. Select the correct answer using the code given below:
With reference to 'fly ash' produced by the power plants using coal as fuel, which of the following statements is/are correct? 1. Fly ash can be used in the production of bricks for building construction. 2. Fly ash can be used as a replacement for some of the Portland cement contents of concrete. 3. Fly ash is made up of silicon dioxide and calcium oxide only, and does not contain any toxic elements. Select the correct answer using the code given below
A draught of 15mm of water is produced by using a chimney of height 30m. The ambient air and flue gases are at 27oC and 300oC respectively. The coal burned on the grate contains 81% carbon, 5% moisture and remaining ash. Neglect the losses and assume values of burnt products equivalent to the volume of air supplied and for the complete combustion of fuel, find the percentage of excess of air supplied?
Which of the following are essential for a good combustion chamber of turbojet engine? 1. It should allow complete combustion of fuel. 2. It should maintain sufficiently high temperature in the zone of combustion in addition to proper atomization of fuel thus leading to continuous combustion. 3. It should not have high rate of combustion. 4. The pressure drop should be as small as possible
What is the theoretical requirement of air (in m3 at STP) for the complete combustion of 100 m3 (at STP) of a fuel consisting of pure CH4? Assume that air contains 21 vol.% of oxygen.
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:
What is minimum amount of air required per m3 of gaseous fuel for complete combustion? m3/m3 of fuel b) 1/100 m3/m3 of fuel c) 1/21 m3/m3 of fuel d) 1/100 m3/m3 of fuel
Study the given pie-chart and answer the question that follows. The pie-chart represents the consumption of fuel (in million litres) by various modes of transport of a country X in the year 2015. The total consumption of fuel by various modes of transport of the country is 800 million litres. (The data shown here is only for mathematical exercise. They do not represent the actual figures of the country.) To obtain fuel, energy is required to run the machinery. which is to be produced by burning coal. If 1 tonne of coal is burnt to produce 0.4 million litres of oil, then approximately what is the requirement of coal (in tonnes) for the Trains sector?
A sample of coal containing the following elements: C=90%; H=5%; ash=4%; weight of the coal burnt=0.90g; weight of the water taken=600g; water equivalent of bomb calorimeter=2000g; rise in temperature=2.48oC; fuse wire correction=10cal; cooling correction=0.02oC; acid correction=50 cal. Calculate net and GCV of coal in cal/g. Assume latent heat of steam is 580cal/g.
Consider the following statements: 1. Coal ash contains arsenic, lead and mercury. 2. Coal-fired power plants release sulphur dioxide and oxides of nitrogen into the environment. 3. High ash content is observed in Indian coal. Which of the statements given above is/are correct?