Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which two classes use the Shape class correctly?
A. public class Circle implements Shape { private int radius; }B. public abstract class Circle extends Shape { private int radius; }C. public class Circle extends Shape { private int radius; public void draw(); }D. public abstract class Circle implements Shape { private int radius; public void draw(); }E. public class Circle extends Shape { private int radius; public void draw() { /* code here */ } }F. public abstract class Circle implements Shape { private int radius; public void draw() { /* code here */ } }
3/4th of square were taken to form shape A and the rest was made to form shape B. Shape A was divided into four equal squares (Shape C), what will be the ratio of the one shape C to one shape B.
The MC curve reaches its minimum point before the AVC curve and the AC curve. In addition the MC curve intersects the AVC curve and the AC curve at their lowest point. The above statements are both true
Which of the following statement(s) is/are true? A. Shape: According to the type of matter, the shape changes depending on the location of the particles. For example, solids have a definite shape, whereas liquids acquire the shape of their vessel and, seen, gases have no shape. B. Filling a vessel of water: It is a property of matter, which decreases in volume under high pressure, and gas shows this property.
Steps are given to draw normal and tangent to an archemedian curve. Arrange the steps, if O is the center of curve and N is point on it. i. Through N, draw a line ST perpendicular to NM. ST is the tangent to the spiral. ii. Draw a line OM equal in length to the constant of the curve and perpendicular to NO. iii. Draw the line NM which is normal to the spiral. iv. Draw a line passing through the N and O which is radius vector.
The minimum Long Run Average Cost (LAC) can be determined on a
I. LAC curve for a normal production function
II. LAC curve for a linear production function
III. Planning curve
IV. Envelope curve
Indicate the correct answer from the following types of the long run average cost curves on which the minimum average cost of production in long run can be determined.
1. Long run average cost curve under normal production function
2. Long run average cost curve under linearly homogeneous production function
3. Planning curve
4. Envelope curve
Match the following:   Curve   Nature of damping I Curve (a) A Un - Damped II Curve (b) B Over Damped III Curve (c) C Under Damped IV Curve (d) D Critically Damped
The question below consists of a set of labelled sentences. Out of the four options given, select the most logical order of the sentences to form acoherent paragraph.
P- The magnitude of the interdependence depends on the technique of production causing the shifts in the food supply curve.
Q- Interdependence of food and labour market is important for the development process.
R- Similarly, an upward shift in the food supply curve shifts up the food demand curve.
S- An upward shift in the food supply curve would simultaneously result in an upward shift in the labour demand curve.
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.