Bissoy.com
Doctors Medicines MCQs Q&A

In the astable multivibrator using IC 555, it can be used as a voltage to frequency converter.

In the astable multivibrator using IC 555, it can be used as a voltage to frequency converter. Correct Answer True

An astable multivibrator can be easily used as a voltage controlled oscillator or as a voltage to frequency converter if a control voltage is applied to the control pin of the IC. The control pin is usually grounded through a capacitor if unused.

Related Questions

A bistable multivibrator with a saturation voltage ±5 V is shown in the diagram. The positive and negative thresholds at the inverting terminal for which the multivibrator will switch to the other state, are
Electronics mcq question image
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
In an astable multivibrator using an op-amp, the feedback factor is 0.5 and the supply voltage is ±12V. What are the quasi-stable output state and the input to the non-inverting terminal?
For an Astable multivibrator shown here, the frequency can be calculated as:
In case of three-phase dual converter, one of the converter circuits is fired at an angle of 60°. For both the converter circuits to have equal average output voltage, what is the value of the firing angle for the other converter circuit?
Given that the charging current of capacitor is constant in a monostable multivibrator using IC 555, then find the type of output waveform, type of capacitor voltage waveform and the time period of output.
Given that the feedback factor of an astable multivibrator is 0.3, find the frequency of the output.
Free running frequency of Astable multivibrator?
How can a monostable multivibrator using IC 555 be used as a PWM generator?
How can the duty cycle be changed for an astable multivibrator?