Bissoy.com
Doctors Medicines MCQs Q&A

Given that transition capacitance is 5 pico F and diffusion capacitance is 80 pico F, and base emitter dynamic resistance is 1500 Ω, find the β cut-off frequency.

Given that transition capacitance is 5 pico F and diffusion capacitance is 80 pico F, and base emitter dynamic resistance is 1500 Ω, find the β cut-off frequency. Correct Answer 7.8 x 106 rad/s

The frequency in radians is calculated by ωβ = 1/C.rbe ωβ = 7.8 x 106.

Related Questions

For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
A transistor is used in common emitter mode as an amplifier. Then a. The base-emitter junction is forward biased b. The base-emitter junction is reverse biased  c. The input signal is connected in series with the voltage applied to the base-emitter junction  d. The input signal is connected in series with the voltage applied to bias the base-collector junction Which of the following statement is true?
Consider a CE circuit, where trans-conductance is 50mΩ-1, diffusion capacitance is 100 pF, transition capacitance is 3 pF. IB = 20μA. Given base emitter dynamic resistance, rbe = 1000 Ω, input VI is 20*sin(107t). What is the short circuit current gain?
For a narrow base PNP BJT, the excess minority carrier concentrations (ΔnE for emitter, ΔpB for base, ΔnC for collector) normalized to equilibrium minority carrier concentrations (nE0 for emitter, pB0 for base, nC0 for collector) in the quasi-neutral emitter, base and collector regions are shown below. Which one of the following biasing modes is the transistor operating in?
Consider an open loop circuit with lower cutoff frequency 5kHz and upper cutoff frequency 20kHz. If negative feedback is applied to the same, choose correct option stating the new cutoff frequencies.
Given collector resistance = 2kΩ, load resistance = 5kΩ, collector capacitance = 1μF, emitter capacitance = 20μF, collector current = 2mA, source resistance = 2kΩ. If the effect of blocking capacitor is ignored, find the applicable cut-off frequency.
A transistor is connected in CB configuration. The emitter voltage is changed by 200mV, the emitter by 5mA. During this transition the collector base voltage is kept constant. What is the input dynamic resistance?
If CT is the transition capacitance, which of the following are true? 1) in forward bias, CT dominates 2) in reverse bias, CT dominates 3) in forward bias, diffusion capacitance dominates 4) in reverse bias, diffusion capacitance dominates
Choose the right option among the alternatives – A transistor conducts in its forward direction when its collector/emitter/base, is positive with respect to its collector/emitter/base, and when a turn-on voltage or current signal is applied to its collector/emitter/base.
Consider the following statements regarding the importance of diffusion and choose the correct answer:
1. The exchange of gases takes place by the principle of dependent diffusion
2. The process of diffusion is involved in transpiration of water vapours
3. The ions are absorbed by the simple diffusion during passive salt uptake
4. Diffusion is an effective means of transport of substances over a very short distance and helps in the translocation of food materials