Bissoy.com
Doctors Medicines MCQs Q&A

From the base bias to the collector feedback configuration, the stability facto S reduces by a factor of __________

From the base bias to the collector feedback configuration, the stability facto S reduces by a factor of __________ Correct Answer 1 + β * R1/(R1 + β)

This can be simply observed from the stability factors of both cases. The correct factor is 1 + β * R1/(R1 + β).

Related Questions

Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?
Consider the following statements with respect to the feedback from the control systems: 1. The feedback can improve stability or be harmful to stability if it is not properly applied. 2. The feedback can always improve stability. 3. In many situations, the feedback can reduce the effect of noise and disturbance on system performance. 4. In general, the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located. Select the correct statements.
Consider the following statements with respect to the feedback of the control systems. i. Feedback can improve stability or be harmful to stability if it is not properly applied. ii. Feedback can always improve stability iii. In many situations the feedback can reduce the effect of noise and disturbance on system performance. iv. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.
Consider the following statements with respect to the feedback of the control systems: 1. Feedback can improve stability or be harmful to stability if it is not properly applied. 2. Feedback can always improve stability 3. In many situations the feedback can reduce the effect of noise and disturbance on system performance. 4. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
The stability factor of a collector feedback bias circuit is ___________ that of base resistor bias.
For a narrow base PNP BJT, the excess minority carrier concentrations (ΔnE for emitter, ΔpB for base, ΔnC for collector) normalized to equilibrium minority carrier concentrations (nE0 for emitter, pB0 for base, nC0 for collector) in the quasi-neutral emitter, base and collector regions are shown below. Which one of the following biasing modes is the transistor operating in?
Collector base feedback and emitter feedback combined together provide stability for self – bias circuits.
Choose the right option among the alternatives – A transistor conducts in its forward direction when its collector/emitter/base, is positive with respect to its collector/emitter/base, and when a turn-on voltage or current signal is applied to its collector/emitter/base.
Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?