Bissoy.com
Doctors Medicines MCQs Q&A

Identify the electrolyte in sodium arsenide plating.

Identify the electrolyte in sodium arsenide plating. Correct Answer Arsenide salt solution

During the process of electroplating, impure metal is kept as anode and pure metal is kept as a cathode. Also for the diffusion of ions to take place, an electrolytic solution is needed which is nothing but metal salt solution (that is arsenide salt solution).

Related Questions

Measurement of KLa in a bioreactor can be carried out by sodium sulfite oxidation method, that is, based on the oxidation of sodium sulfite to sodium sulfate in the presence of a catalyst (Cu++ or Co++). In a typical experiment, a laboratory fermenter was filled with 5 liter of 0.5 M sodium sulfite solution containing 0.003 M Cu++ ions and the air was sparged in. After 10 min, the air flow was stopped and a 10 mL sample was taken and titrated. The concentration of sodium sulfite in the sample was found to be 0.20 M. The oxygen uptake rate for this aerated system will work out to be
A trapezium plate having two parallel sides of length 17 cm and 11 cm, and distance between them is 8 cm. Silver plating is to be done on the plate at a rate of Rs. 2 per square cm. What will be the total cost of silver plating?
Calculate the radioactive minority carrier lifetime in gallium arsenide when the minority carriers are electrons injected into a p-type semiconductor region which has a hole concentration of 1018cm-3. The recombination coefficient for gallium arsenide is 7.21*10-10cm3s-1.
Aqueous solution of following compounds electrolysed separately, Acetylene gas is obtained from:- (i) Sodium fumerate      (ii) Sodium maleate      (iii) Sodium succinate      (iv) Sodium acetate
With reference to street-lighting, how do sodium lamps differ from LED lamps? 1. Sodium lamps produce light in 360 degrees but it is not so in the case of LED lamps. 2. As street lights, sodium lamps have a longer life span than LED lamps. 3. The spectrum of visible light from sodium lamps is almost monochromatic while LED lamps offer significant colour advantages in street lighting. Select the correct answer using the code given below.  
In case of an automobile battery, following are the reasons which will cause a defect of
1. Very high charging rate
2. High specific gravity of electrolyte
3. Freezing of electrolyte
4. Improper level of electrolyte
5. Mechanical damage due to rough handling or not fixed in the vehicle
Which of the following is used as an electrolyte for antimony Plating?
The electrolyte used in soft metal Plating is _____________
Which electrolyte is used for tin plating?
There are two beakers with the first containing sodium hydroxide solution and the other beaker has twice the quantity of water. To prepare a solution, 60 ml of sodium hydroxide is added to the water beaker. Three fourth of the prepared solution is again added to the first beaker. After this the first beaker has 3.5 times the solution in the water beaker. How much was the initial amount of sodium hydroxide?