Bissoy.com
Doctors Medicines MCQs Q&A

In Multicast Routing Protocol, flooding is used to broadcast packets but it creates ________

In Multicast Routing Protocol, flooding is used to broadcast packets but it creates ________ Correct Answer Loops

In multicast routing, there is one sender and many receivers. So flooding is the most basic method to forward packets to many receivers. The one issue with flooding is that it creates routing loops. One loop prevention method is that the routers will not send the packet to a node where the packet has been received before.

Related Questions

Consider the following statements about the routing protocols. Routing Information Protocol (RIP) and Open Shortest Path First (OSPE) in an IPv4 network. I. RIP uses distance vector routing II. RIP packets are sent using UDP III. OSPF packets are sent using TCP IV. OSPF operation is based on link-state routing Which of the statements above are CORRECT?
Consider the following question and decide whether the statements are sufficient to answer the question. Question: In a box, there are packets of three different sizes. How many packets are there in the box? Statements: 1. Half of all the packets are of medium size. 2. There are six big packets. 3. There are twice the amount of small packets than there are big packets.
Surjeet bought 48 packets of red balloons, 66 packets of blue balloons, and 35 packets of yellow balloons. Each pack contained a dozen balloons. He mixed them up and gave away 213 balloons. Then, he repacked the remainder into packets of 25 balloons each. How many packets of balloons did he repack?
Consider the following three statements about link state and distance vector routing protocols, for a large network with 500 network nodes and 4000 links. [S1] The computational overhead in link state protocols is higher than in distance vector protocols. [S2] A distance vector protocol (with split horizon) avoids persistent routing loops, but not a link state protocol. [S3] After a topology change, a link state protocol will converge faster than a distance vector protocol. Which one of the following is correct about S1, S2, and S3?
Which statement is true regarding classless routing protocols?
1. The use of discontiguous networks is not allowed.
2. The use of variable length subnet masks is permitted.
3. RIPv1 is a classless routing protocol.
4. IGRP supports classless routing within the same autonomous system.
5. RIPv2 supports classless routing.
You want to enable dynamic routing on a Windows 2000 Server computer on your TCP/IP network . You want this computer to manage the propagation of multicast traffic throught your network. Which routing protocol should you use?
Which of the following routing technique/techniques is/are used in distributed systems? (a) Fixed Routing (b) Virtual Routing (c) Dynamic Routing
An owner of a Dry fruits shop sold small packets of mixed nuts for Rs. 150 each and large packets for Rs. 250 each. One day he sold 5000 packets, for a total of Rs. 10.50 lakh. How many small packets were sold ?
Consider a computer network using the distance vector routing algorithm in its network layer. The partial topology of the network is as shown below. The objective is to find the shortest-cost path from the router R to routers P and Q. Assume that R does not initially know the shortest routes to P and Q. Assume that R has three neighbouring routers denoted as X, Y, and Z. During one iteration, R measures its distance to its neighbours X, Y, and Z as 3, 2, and 5, respectively. Router R gets routing vectors from its neighbours that indicate that the distance to router P from routers X, Y, and Z are 7, 6, and 5, respectively. The routing vector also indicates that the distance to router Q from routers X, Y, and Z are 4, 6, and 8, respectively. Which of the following statement(s) is/are correct with respect to the new routing table of R, after updation during this iteration ? 
________ serve as multicast forwarding agents and are meant to isolate the mobility of the mobile host from the main multicast delivery tree.