Bissoy.com
Doctors Medicines MCQs Q&A

In Novell’s use of RIP, there are two metrics used to make routing decisions. Select the correct metrics.

In Novell’s use of RIP, there are two metrics used to make routing decisions. Select the correct metrics. Correct Answer Ticks & Hops

It first uses ticks (which is about 1/18 sec.); if there is a tie, it uses hops; if hops are equal, then it uses an administratively assigned tiebreaker.

Related Questions

Consider the following statements about the routing protocols. Routing Information Protocol (RIP) and Open Shortest Path First (OSPE) in an IPv4 network. I. RIP uses distance vector routing II. RIP packets are sent using UDP III. OSPF packets are sent using TCP IV. OSPF operation is based on link-state routing Which of the statements above are CORRECT?
A network administrator views the output from the show ip route command. A network that is advertised by both RIP and IGRP appears in the routing table flagged as an IGRP route. Why is the RIP route to this network not used in the routing table?
A network administrator views the output from the show ip route command. A network that is advertised by both RIP and IGRP appears in the routing table flagged as an IGRP route. Why is the RIP route to this network not used in the routing table?
Which statement is true regarding classless routing protocols?
1. The use of discontiguous networks is not allowed.
2. The use of variable length subnet masks is permitted.
3. RIPv1 is a classless routing protocol.
4. IGRP supports classless routing within the same autonomous system.
5. RIPv2 supports classless routing.
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
Novell’s implementation of RIP updates routing tables every _________ seconds.
Consider a computer network using the distance vector routing algorithm in its network layer. The partial topology of the network is as shown below. The objective is to find the shortest-cost path from the router R to routers P and Q. Assume that R does not initially know the shortest routes to P and Q. Assume that R has three neighbouring routers denoted as X, Y, and Z. During one iteration, R measures its distance to its neighbours X, Y, and Z as 3, 2, and 5, respectively. Router R gets routing vectors from its neighbours that indicate that the distance to router P from routers X, Y, and Z are 7, 6, and 5, respectively. The routing vector also indicates that the distance to router Q from routers X, Y, and Z are 4, 6, and 8, respectively. Which of the following statement(s) is/are correct with respect to the new routing table of R, after updation during this iteration ? 
Which of the following routing technique/techniques is/are used in distributed systems? (a) Fixed Routing (b) Virtual Routing (c) Dynamic Routing
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
Two statements are given followed by two conclusions as responses. You have to consider the statements to be true even if they seem to be at variance from the commonly known facts. You have to decide which of the given conclusion(s) can definitely be drawn from the given statements. Statements: All the decisions of the UNSC are binding upon the members of the UN. Countries like Lebanon have failed to follow the decisions taken by the UNSC. Conclusion: UNSC cannot completely control all the member countries by making them follow its decisions.        II. Not all countries follow the decisions taken by the UNSC.