Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Which of the following statement are true from reliability for a research tool? (a) Reliability is fixed for a given testing tool (b) It is correlation of scores on the testing tool itself (c) Reliability can have negative value (d) It varies from sample to sample (e) It is affected by variance of scores Choose the correct option:
Consider the following statements to be true even if they seem to be at variance from commonly known facts and decide which of the conclusions logically follows from the statements. Statements: Some pan are card. No card are tool. Conclusions: I. Some tool are pan. II. All pan are tool. 
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
“Tool bit inserted in the (tool) holder and solid tool” – is included in the classification according to the_____
Which of the following statements is/are correct? 1. A system is said to be Finite Impulse Response (FIR), if the output samples of the system depend only on the present input and a finite number of past or previous input samples. 2. If the output of a system y(n) depends only on the present input and past inputs, but not on past outputs, then it is called a non-recursive system. 3. If the output of a system y(n) depends only on the present input and past inputs, but not on past outputs, then it is called a recursive system.
Consider the following statements: I. The trigonometric ratio can be measured by measuring the angles in circular system but not in centesimal system and sexagesimal system II. The trigonometric ratio can be measured by measuring the angles in circular system and centesimal system but not in sexagesimal system
Consider the following statements regarding Peer-to-Peer computing environment: 1. In this system, clients and servers are not distinguished from one another. 2. All nodes distributed throughout the system (within) are considered Peers and each may act as either a client or a server. 3. Peer-to-Peer system assuredly offers certain advantages over the traditional client-server system. 4. Peer-to-Peer system is just a replica of the file-server system. Which of the above statements are correct?
Which of the following statements with respect to multiprocessor system are true? (A) Multiprocessor system is controlled by one operating system. (B) In Multiprocessor system, multiple computers are connected by the means of communication lines. (C) Multiprocessor system is classified as multiple instruction stream and multiple data stream system. Choose the correct answer from the options given below: