Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not a decompiler tool?

Which of the following is not a decompiler tool? Correct Answer Borol and C

Decompilers are part of Reverse Engineering tools that try to generate high-level code. Some common decompiler tools are DCC decompiler, Boomerang Decompiler, ExeToC, REC (reverse engineering compiler) etc.

Related Questions

Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
In choosing a research tool which of the following are important considerations? A. The validity of the research tool B. The reliability of the research tool C. cost involved in terms of time and resources for use of research tool. D. Face validity of the research tool E. Opinion of the research supervisor Select the correct answer from the following options:
Which one is not an example of .Net application decompiler?
Which of the following statement are true from reliability for a research tool? (a) Reliability is fixed for a given testing tool (b) It is correlation of scores on the testing tool itself (c) Reliability can have negative value (d) It varies from sample to sample (e) It is affected by variance of scores Choose the correct option:
Consider the following statements to be true even if they seem to be at variance from commonly known facts and decide which of the conclusions logically follows from the statements. Statements: Some pan are card. No card are tool. Conclusions: I. Some tool are pan. II. All pan are tool. 
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
“Tool bit inserted in the (tool) holder and solid tool” – is included in the classification according to the_____
Consider the following statements concerning e-governance and technology: 1. Rich Site Summary (RSS) is not a very useful tool for working on Web-service technology 2. Myspace is one of the most visited networks in the world 3. Facebook.com is not the most useful social networking site of choice for most students 4. Wiki- is a group collaboration software tool working on Web-service technology Which of the above statements are correct?
Frequent changing of the tool for different operations need not be done in four way tool post.
Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?