Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which one of the following four addresses is NOT EXACTLY the same as the one given below? Jennifer Stenvin 23/198 B, Walkswagen  malaviyen street Stempho guestur London i. Jennifer Stenvin 23/198 B, Walkswagon  malaviyen street Stempho guestur London ii. Jennifer Stenvin 23/198 B, Walkswagen  malaviyen street Stempho guestur London iii. Jennifer Stenvin 23/198 B, Walkswagen  malaviyen street Stempho guestur London iv. Jennifer Stenvin 23/198 B, Walkswagen  malaviyen street Stempho guestur London
Determine carrier velocity of a p-i-n photodiode where 3dB bandwidth is1.9×108Hz and depletion region width of 24μm.
There is a numeric lock which has a 3-digit PIN. The PIN contains digits 1 to 7. There is no repetition of digits. The digits in the PIN from left to right are in decreasing order. Any two digits in the PIN differ by at least 2. How many maximum attempts does one need to find out the PIN with certainty?
An Internal combustion engine has a connecting rod of mass 2 kg and the distance between the centre of crank and centre of gudgeon pin is 25 cm. The Center of Gravity lies at a point 10 cm from the gudgeon pin along the line of centres. The radius of gyration of this system about an axis through the Center of Gravity perpendicular to the plane of rotation is 11 cm. If two masses are used instead of the connecting rod, one at the gudgeon pin and other at the crank pin. What will be the new radius of gyration?
An Internal combustion engine has a connecting rod of mass 2 kg and the distance between the centre of crank and centre of gudgeon pin is 25 cm. The Center of Gravity lies at a point 10 cm from the gudgeon pin along the line of centres. The radius of gyration of this system about an axis through the Center of Gravity perpendicular to the plane of rotation is 11 cm. If two masses are used instead of the connecting rod, one at the gudgeon pin and other at the crank pin, if the angular acceleration of the rod is 23 000 rad/s2, then find the correction couple in N-m.
Below are given two sets, Set - I which gives modalities of operant conditioning and Set - II which provides the types of reinforcement, the types of responses (responses made or withheld) and the presence or absence of cue. Match the two sets and indicate your answer by choosing from the code : Set - I (Modalities of operant conditioning procedures) Set – II           (Conditions and contexts) (a) Reward training (i) Positive reinforcement, response made, with cue present (b) Escape training (ii) Positive reinforcement, response withheld with cue absent (c) Discriminated omission training   (iii) Positive reinforcement, response made with cue absent (d) Active avoidance   (iv) Negative reinforcement, response made with training (e) Punishment training (v) Positive reinforcement, response withheld with cue present   (vi) Negative reinforcement, response withheld with cue absent  
Compute maximum 3 dB bandwidth of p-i-n photodiode if it has a max response time of 5.8 ns.
Consider the following statements with reference to the response of a control system: 1. A large resonant peak corresponds to a small overshoot in transient response. 2. A large bandwidth corresponds to slow response. 3. The cut-off rate indicates the ability of the system to distinguish the signal from noise 4. Resonant frequency is indicative of the speed of transient response. Which of the above statements are correct?
Each question presents a situation and asks you to make a judgement regarding that particular circumstance. Choose an answer based on given information. Aman has a debit card of XYZ bank. The card has 4-digit pin. Aman has not used his card for a while. He does not remember the pin even though he remembers some of the key points. 1. The 2nd digit was even number but not 2. 2. The 4th digit was 6. 3. The 3rd digit from the left was an odd number greater than 5. 4. The 1st digit from the left was an even prime number. Which of the following would be most likely the pin number?
Referring this circuit, determine the maximum output voltage when a single pulse is applied as shown. The total resistance is 60 Ω.
Time Response of Reactive Circuits mcq question image