Bissoy.com
Doctors Medicines MCQs Q&A

Shown below is the diagram of an ideal super diode. When the input voltage Vin is negative, then the output voltage Vout = ?

Shown below is the diagram of an ideal super diode. When the input voltage Vin is negative, then the output voltage Vout = ? Correct Answer 0

When the input voltage is negative, there would be a negative voltage on the diode so it works like an open circuit. Hence no current flows through the load and Vout is zero.

Related Questions

Shown below is the diagram of an ideal super diode. When the input voltage Vin is positive, then the output voltage Vout = ?
In the circuit shown below voltage Vin is 3V and VB is 1V. The resistor R1 and R2 are 1K. Assume both diodes are identical. Forward bias resistance is 10Ω. Cut-in voltage of diode is 0.7V. The voltage Vout is __________
In the circuit shown below voltage Vin is -3V and VB is -1V. The resistor R1 and R2 are 1K. Assume both diodes are identical. Forward bias resistance is 10Ω. Cut-in voltage of diode is 0.7V. The voltage Vout is __________
In the circuit shown below voltage Vin is 3V and VB1 is -1V and VB2 is 1V. Assume both diodes are identical. Cut-in voltage of diode is 0.7V. Forward bias resistance is 10Ω. The voltage Vout is __________
A sinusoidal input voltage Vin of frequency ω is fed to the circuit shown in the figure, where C1 ≫ C2. If Vm is the peak value of the input voltage, then output voltage (Vout) is
Electronics mcq question image
The voltage across the diode Vout if Vin is -5V and resistance is 10K is? (Use constant voltage drop model of diode and take VD as 0.5V)
The voltage across the diode Vout if Vin is 5V and resistance is 10K is? (Use constant voltage drop model of diode and take VD as 0.5V)
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
The voltage VOUT across the ideal diode if VIN is-5V and resistance R1=10KΩ is ___________
In the figure, D1 is a real silicon p-n junction diode with a drop of 0.7 V under forward bias condition and D2 is a Zener diode with breakdown voltage of -6.8 V. The input Vin(t) is a periodic square wave of period T, whose one period is shown in the figure. Assuming 10τ ≪ T, where τ is the time constant of the circuit, the maximum and minimum values of the output waveform are respectively,