Power amplifiers handle ____________ signals compare to voltage amplifiers

Power amplifiers handle ____________ signals compare to voltage amplifiers Correct Answer large

The Small Signal Amplifier is generally referred to as a “Voltage” amplifier because they usually convert a small input voltage into a much larger output voltage. Although the amplification is high the efficiency of the conversion from the DC power supply input to the AC voltage signal output is usually poor.
Bissoy MCQ

Related Questions

Power amplifiers handle ___________ signals compare to voltage amplifiers
The handle of a saucepan, 30 cm long and 2 cm in diameter, is subjected to 100 degree Celsius temperature during a certain cooking operation. The average unit surface conductance over the handle surface is 7.35 W/m2 degree in the kitchen air at 24 degree Celsius. The cook is likely to grasp the last 10 cm of the handle and hence the temperature in this region should not exceed 38 degree Celsius. What should be the thermal conductivity of the handle material to accomplish it? The handle may be treated as a fin insulated at the tip
You are given two amplifiers, A and B, to connect in cascade between a 10-mV, 100-kΩ source (S) and a 100-Ω load (L). The amplifiers have voltage gain, input resistance, and output resistance as follows: for A, 100 V/V, 10 kΩ, 10 kΩ, respectively; for B, 1 V/V, 100 kΩ, 100 Ω, respectively. Your problem is to decide how the amplifiers should be connected so that the voltage gain is maximum.
Chopper stabilized dc amplifiers are complex amplifiers having ________ amplifiers incorporated in the module.
The best way to compare the different implementations of symbol table is to compare the time required to ____________
Which of the power amplifiers is not suitable as audio amplifiers?
Improve the bracketed part of the sentence. The duos network was (made to learn identify) true signals using previously vetted signals; they then studied the weaker signals.
The capture/compare registers TBCCRn are double-buffered when used for compare events?
While working with MS-DOS, which command is used to compare the disk in drive A with the disk in drive B, specifying to compare only first side of each disk, and only the first 8 sectors of each track?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the power factor at this operation mode will be ____________