The value of dBm in power measurement is predictable by assuming the reference, which is equal to ________

The value of dBm in power measurement is predictable by assuming the reference, which is equal to ________ Correct Answer 1mW

Basically, the Decibel (dB) is a logarithmic unit which is used to state the gain of audio frequency amplifiers. This is so for the reason that the response of a human ear to the sound intensity exhibits logarithmic nature. Apart from this, dBm is a unit which is often used in power measurement. dBm refers to the dB value which is estimated by assumption of a reference whose value is equal to 1mW.
Bissoy MCQ

Related Questions

A GSM cellular telephone standard requires a minimum of 9 dB rejection of interfering signal levels of -23 dBm at 3 MHz from the carrier, -33 dBm at 1.6 MHz from the carrier, and -43 dBm at 0.6 MHz from the carrier, for a carrier level of -99 dBm. Determine the required local oscillator phase noise at 3 MHz carrier frequency offset.
If the received power at the antenna terminals is Si=-80 dBm and the output noise power is -110 dBm then the output signal to noise ratio is given by:
For a receiver, 1 dB compression point is 25 dBm and the noise power at the receiver output is -47.4 dBm, the linear dynamic range is:
An X- band amplifier has a gain of 20 dB and a gain of 1GHz bandwidth. Noise figure of the amplifier is -62 dBm at 290 K and -64.7 dBm at 77 K. then the Y factor of the amplifier is :
If the third order input intercept point of a mixer is 13 dBm and if the mixer has a conversion loss of 6 dBm, then the third order intercept point at the output is:
If the third order intercept point of a receiver is 35 dBm and the total noise in the receiver is -47.4 dBm signals to noise ratio is 10, then the spurious free dynamic range is:
Which among the following are the anthropometric procedures for measurement?
1. Length measurement
2. Head circumference measurement
3. Weight measurement
4. Waist measurement`
Select differences between reference type and value type: i. Memory allocated to ‘Value type’ is from heap and reference type is from ‘System. ValueType’ ii. Memory allocated to ‘Value type’ is from ‘System. ValueType’ and reference type is from ‘Heap’ iii. Structures, enumerated types derived from ‘System. ValueType’ are created on stack, hence known as ValueType and all ‘classes’ are reference type because values are stored on heap
Which among the following are the procedures for taking measurements?
1. Body measurement
2. Sleeves measurement
3. Shirt measurement
4. Pant measurement
What of these can be used as a reasonable model for measurement system capability studies? Here y,x and ε denote the observed measurement, true measurement, and the measurement error respectively.