If the ratio RB / RE tends to infinity, what should be the value of stability factor in voltage divider circuit?

If the ratio RB / RE tends to infinity, what should be the value of stability factor in voltage divider circuit? Correct Answer 1 + βdc

Stability factor is fundamentally dependent on the ratio of base resistance to emitter resistance(RB / RE). Hence, if this ratio is estimated to be small, then the stability factor in such case is equal to unity. On the contrary, if this ratio RB / RE tends to infinite value, then the value of stability factor in voltage divider circuit becomes nearly equivalent to 1+ βdc. Therefore, if the ratio is constant then it leads to an increase the stability factor by increasing the value of current gain (βdc). Besides this, smaller values of base resistance also yield improved stabilization.
Bissoy MCQ

Related Questions

The uniform distribution can range from -infinity to 0 or 0 to Infinity but not from -infinity to infinity.
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation which of these capacitor should have minimum value?
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation of clapp oscillator value of C3 should be __________
What is/are true about ridge regression?
1. When lambda is 0, model works like linear regression model
2. When lambda is 0, model doesn't work like linear regression model
3. When lambda goes to infinity, we get very, very small coefficients approaching
04. When lambda goes to infinity, we get very, very large coefficients approaching infinity.
In M-ary FSK as M tends to infinity, probability of error tends to
Wilkinson power divider is an equal split power divider.
If source resistance in an amplifier circuit is zero, then voltage gain (output to input voltage ratio) and source voltage gain (output to source voltage ratio) are the same.
Examine the following statements :
i) Factor of safety for steel should be based on its yield stress,
ii) Factor of safety for steel should be based on its ultimate stress,
iii) Factor of safety for concrete should be based on its yield stress,
iv) Factor of safety for concrete should be based on its ultimate stress.
The correct statements are
For a Voltage divider bias circuit, having R1=R2=10KΩ, RC=4.7 KΩ, RE=1 KΩ, What is the value of collector current at saturation if VCC=10V?
For the voltage divider circuit, if a diode is connected in reverse direction across the base Find the value of β? (Vd=1.2v and input is 1V)