The___________ configuration is used frequently for impedance matching.

The___________ configuration is used frequently for impedance matching. Correct Answer emitter follower

The emitter follower configuration is mostly used as a voltage buffer. These configurations are extensively used in impedance matching applications because of their high input impedance.
Bissoy MCQ

Related Questions

After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
A single section tapered line is more efficient in impedance matching than a multisection tapered line for impedance matching.
When impedance matching is done between a resonator and a feed line, the condition for impedance matching is:
A two wire transmission line of characteristic impedance Z is connected to a load impedance ZL(ZL and Zo are not equal). Impedance matching cannot be achieved with
The mean square thermal noise current in the trans-impedance configuration is _________ greater than that obtained with the high-input-impedance configuration.
In series stub matching, if the normalized impedance at a point on the transmission line to be matched is 1+j1.33. Then the reactance of the series stub used for matching is:
If a single section quarter wave transformer is used for impedance matching at some frequency, then the length of the matching line is:
Chebyshev matching transformers can be universally used for impedance matching in any of the microwave networks.
CC configuration is used for impedance matching because its ___________
Which of the following configuration is used for impedance matching?