An L section filter with L=2henry and C= 49µF is used in the output of a full wave single phase rectifier that is fed from a 40-0-40 V peak transformer. The load current is 0.2A. Calculate the output dc voltage.

An L section filter with L=2henry and C= 49µF is used in the output of a full wave single phase rectifier that is fed from a 40-0-40 V peak transformer. The load current is 0.2A. Calculate the output dc voltage. Correct Answer 24.46V

Given, VL= 40V. VDC=2/π*VL=2/π*40=25.46V.
Bissoy MCQ

Related Questions

Match the following: (i) Half wave rectifier p) Transformer not required (ii) Full wave rectifier  q) Centre tap transformer required (iii) Full wave bridge rectifier r) Ordinary transformer required
A step-down delta-star transformer, with per-phase turns ratio of 5 is fed from a 3-phase 1100 V source. The secondary of this transformer is connected through a 3-pulse type rectifier, which is feeding an R load. The power delivered to the load is 6839.3 Watts. The maximum value of the load current is √2 x 22 A. Fin, the rms value of output voltage Vo (rms)
A step-down delta-star transformer, with per-phase turns ration of 5, is fed from a 3-phase, 1100 V, 50 Hz source. The secondary of this transformer through a 3-pulse type rectifier feeds a R load of 10 Ω. Find the maximum value of the load current (phase).
A single phase full wave rectifier makes use of pi section filter with 10µF capacitors and a choke of 10henry. The secondary voltage is 280V and the load current is 100mA. Determine the dc output voltage when f=50Hz.
A full wave rectifier with a load resistance of 5KΩ uses an inductor filter of 15henry. The peak value of applied voltage is 250V and the frequency is 50 cycles per second. Calculate the dc load current.
A step-down delta-star transformer, with per-phase turns ratio of 5 is fed from a 3-phase 1100 V, 50 Hz source. The secondary of this transformer is connected through a 3-pulse type rectifier, which is feeding feeding an R load. Find the average value of output voltage.
A single-phase diode B-2 rectifier is fed from a 250 V, 50 Hz source & connected to a load of R = 400 Ω. Design a capacitor filter such that the ripple factor of the output voltage is less than 5 %. Find the value of the capacitance of the C filter.
An AC voltage of 220 V(rms) is applied to the primary of a 10 : 1 step-down transformer. The secondary of the transformer is centre tapped and connected to a full-wave rectifier with a load resistance. The DC voltage appearing the load is
Find the expression of the rms value of output voltage for a single-phase M-2 type rectifier with RL load and continues load current. Transformer ratio is 1:1 with supply voltage Vs = Vm sinωt
A rotary drum filter with 30% submergence is used to filter concentrated aqueous slurry of calcium carbonate containing 15lb of solids per cubic foot of water. The pressure–drop is 2011Hg. If the filter cake contains 50% mixture (wet basis), calculate the filter area required to filter 10 gal/min of slurry. The filter cycle time is 5 min. The specific cake resistance depends on the pressure–drop as: α (ft/lb) = α (Δp)0.26, where α = 2.90×1010 Viscosity of the filtrate = 6.72×10-4 lb/ft-s. Density of calcium carbonate = 168.8 lb/ft3. Neglect filter medium resistance.